Bmw Z3 1996

• Recall 60705 [USA]: Without the amber reflectors, the vehicle will be poorly illuminated, possibly resulting in a vehicle crash without warning.
  Certain pro-a motors corner lamps, turn signals, and headlights sold as replacement lamps for use on certain passenger vehicles listed above. Some combination lamps that are not equipped with amber side reflectors fail to conform to federal motor vehicle safety standard no. 108, lamps, reflective devices, and associated equipment.
  pro-a motors will notify owners and offer to repurchase the lamps. The recall began on april 3, 2006. Owners may contact pro-a motors at 323-838-2988.
  this recall only pertains to pro-a motors aftermarket lamps and has no relation to any original equipment installed on the listed passenger vehicles.For more information on the lamp model numbers, click on document search and view document titled "lamp model numbers."customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 16179 [USA]: This could cause the throttle valve to remain partially open. it his were to occur, the car might not decelerate as expected increasing the risk of a vehicle crash.
  The cruise control and throttle cables are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break due to environmental influences coupled with vibration. If the bushing breaks, the outer cable housing can separate from the bushing. In this case, during application of the throttle pedal without cruise control being engaged, the outer tube could catch on the edge of the broken bushing.
  dealers will install a spring steel clip on the outer tube of each cable in the area of the adjusting screw and plastic bushing. The clip is designed to prevent the outer tube from dislodging from the bushing.
  owner notification is expected to begin by the end of october 1997. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact bmw at 1-800-831-1117.Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

  Show Content

• Recall 1997173 [Canada]: Engine
  On certain 318ic, 318is, 318ti, 325i, 325ic, 325is, 525i, 525it, 530i, 530it, 540i, 740i, 740il, 840ci and m3, the cruise control and throttle cable are attached to the same throttle valve actuating lever at the throttle housing. It is possible that the plastic bushing on either cable could break causing the outer cable housing to separate from the bushing. Throttle pedal application without cruise control engagement could cause the outer tube to catch on the edge of the broken bushing resulting in the throttle valve remaining partially open. If this were to occur, the car might not decelerate as expected and a crash could occut. Correction: a spring clip will be installed on the outer tube of each cable to prevent dislodgment from the bushing.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

Driver seat sliding back and forth while driving in motion

Tl* the contact owns a 1996 bmw z3. While the vehicle was stationary, the driver's seat heater malfunctioned. The contact stated that the seat heater burned a hole in the leather seat and also burned a hole in her jeans. The contact was not injured. The vehicle was not repaired. The manufacturer was made aware of the failure. The failure mileage was 100,000.

Tl* the contact owns a 1996 bmw z3. The contact stated that the air bag warning light illuminated. The contact also stated that the seat belt could not be unlatched when the driver would depress or add any pressure to the brake pedal. The vehicle was taken to the dealer for inspection and they stated that the air bag sensor and the seat belt assembly needed to be replaced. The vehicle was repaired. The manufacturer was notified of the failure. The failure mileage was 75,000.

Driver and passenger seats move forward/backwards during acceleration and breaking at any speed, gas gauge reads empty on full tank or fluxes on dash and air bag light stays on for 3-5 min. At a time when starting up ignition. *tr

Tl* the contact owns a 1996 bmw z3. The contact stated that there was an increase in exhaust fumes and a rattling noise was coming from the catalic converter. The contact also stated that erosion in the monolith became loose in the housing. The check engine light would also illuminate on the instrument panel at any time. The dealer and manufacturer denied any assistance with repairs of the failure. The vehicle was not repaired. The failure mileage was 94,000 and the current mileage was 97,000. Updated 09/21/11 *bf updated 10/07/11

The driver seat moves forward when the brakes are applied hard. My mechanic says that this is a common problem with the z3's. *tr

Srs light came on after adjusting the seat. Bmw has issued several service bulletins re srs problems, so clearly they are aware of the problem. Yet bmw refuses to issue a recall to properly retrofit the wiring harness.*ak

Srs light came on after adjusting the seat. According to reports from numerous z3 owners, this a common problem. Bmw has issued several service bulletins regarding this problem. As srs failure could result in serious injury or death, bmw should correct the problem by properly redesigning the defective part(s). *jb

The airbag warning light has come on, been repaired by the manufacturer, and has come on again. Manufacturer states that airbags will not operate properly without repair. *la