Bmw Z3 2004
Vehicle Details: Recalls, Service Bulletins
BMW VIN Decoder
Use the box here to look up VINs from BMW as well as other manufacturers
Frequently Asked Questions
-
Where is the 2004 BMW Z3 produced?
- The 2004 BMW Z3 is produced in Greer Sc, United States (usa).
-
Are there recalls for the 2004 BMW Z3?
- There are 1 recall(s) for the 2004 BMW Z3, additional information is below.
NHTSA Mandated Recalls
Bulletins
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- B611305 - ELECTRICAL SYSTEM: The electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This document covers important information for the dealer on ho
- B611305 - EQUIPMENT ADAPTIVE/MOBILITY: Discharged battery energy diagnosis must be performed: the electrical system of bmw vehicles has been subject to an ongoing development process over the last few years. This has led to increased demands being placed on the battery. This doc
- SIB-61-13-05 - ELECTRICAL SYSTEM:12V/24V/48V BATTERY: Bmw: battery has an increased demand due to developemental process of the electrical system. This is causing the batter to need to undergo an energy diagnosis. *kb
- SI B12 12 10 - ENGINE AND ENGINE COOLING: Bmw: when at lower speeds or stopping the engine idle dips too low because of a software problem. *rm
- SIB-63-02-01 - EXTERIOR LIGHTING: Bmw: procedure for determining and replacing incandescent and halogen light bulbs under warranty. *rm
- SIB-32-04-07 - STEERING:ELECTRIC POWER ASSIST SYSTEM: Bmw: a new technical process has been created for bmw to identify causes of steering complaints with a wide range of models. *rm
- SIB-16-02-09 - FUEL SYSTEM, GASOLINE:DELIVERY:FUEL PUMP: Bmw vehicles: fuel level sensor repairs. Where it is necessary to replace the right or the left side fuel level sensor due to a failure, the entire pump and housing or delivery unit (suction jet assembly) do not need to be replaced as wel