1968 CHEVROLET C SeriesChevrolet C Series 1968

Vehicle Details: Recalls, Consumer Complaints, Service Bulletins

Below you will find all available information on the 1968 CHEVROLET C Series, manufacturered by General Motors Llc.

ManufacturerKnown WMI(s)Fuel Type
CHEVROLET1G8 1GA 1GB 1GC 2GA 2GB 2GC 3GB
CHEVROLET VIN Decoder

Use the box here to look up VINs from CHEVROLET as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 1968 CHEVROLET C Series produced?
     - The 1968 CHEVROLET C Series is produced in Warren Michigan, United States (usa).
  • Are there recalls for the 1968 CHEVROLET C Series?
     - There are 1 recall(s) for the 1968 CHEVROLET C Series, additional information is below.
NHTSA Mandated Recalls
  • Recall 56919 [USA]: Unexpected loss of throttle control may cause loss ofvehicle control and an accident.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • WB11-X-001A - ENGINE AND ENGINE COOLING: The following information is provided to clearly explain isuzua??S policy for control module (engine, transmission, antilock brake, instrument panel, body control, power interface, etc.) reprogramming. Control module calibrations are regula
Most Recent Consumer Complaints and Accidents
CrashFireTowedInjuredDeathsFailure
Date
NoNoN NoneNone20010602

The rear tire on my pickup failed while traveling on the freeway at apx 70 mph. The left rear tread separated from the carcass at speed. The remaining 3 tires have on average 5-6 mm of tread remaining. The tire pressure was checked the day before 53 psi and i increased the pressue to 60 to match the other tires. The vehicle was partially loaded with apx 600 lbs in the rear. The tires were original equippment "take off" tires and rims for a 93 f250. The tires and wheels were purchased as a matched set with less than 600 miles wear, from a ford dealership in late 93 or early 94. I am naturally concerned for my safety with the remaining 3 firestone tires. The tire demonstrated no bulging, edge separation, "thumping" or flat spots prior to failure. The tire did show signs of a slow leak with a loss of 2-4 psi a month when set at 60 psi. Repeated inspections for nails, screws, punctures or sidewall damage were negative. I attributed the tire pressure loss to a bad valve stem. The wear pattern on the remaining tires is consistent with normal operation. I use the vehicle recreationaly and not for work. Please help, what should i do??? (dot number: vnor1wt103 tiresize: lt23585r16)

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.