Chevrolet Caprice 1989

• Recall 89516 [USA]: This condition may cause inadequate sealing and loss of engine oil, possibly resulting in a fire.
  Certain honeywell fram racing brand hp4 and hp8 oil filters that were manufactured from may 25, 2006, through september 14, 2007, and sold for use as replacement equipment for vehicles list above. The affected filters are marked with a date code a61451 through a72571 sequentially. The date code and part number appear on the filter housing. Fram racing hp4 and hp8 oil filters not bearing a date code in this range are not affected by this recall. The gasket of the oil filter becomes more pliable under high temperatures and pressures.
  honeywell will replace the affected oil filters free of charge. The recall began during november 2007. Owners can contact fram customer service toll-free at 1-800-890-2075.
  customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 59534 [USA]: This condition may cause an inadequate seal at the connection, potentially leading to a fuel leak. in the presence of an ignition source, a fire could occur.
  Certain replacement fuel filters, fram brand name p/n g3727, with date codes x52911 through x60801 sequentially or x600141 and a mexico country or origin marking on the fuel filter housing manufactured from october 18, 2005, through march 21, 2006, sold for use on the vehicles listed above and on certain school buses. (to see the school bus engine sizes, click on "document search" and then "bus applications"). The connector on the fuel filter was not manufactured to honeywell's specification. As a result, the o-ring may not seat correctly on the fuel line.
  honeywell will notify owners and replace the fuel filters free of charge. The recall began on october 18, 2006. Owners may contact fram customer service at 1-800-890-2075 (option 1).
  this recall only pertains to aftermarket fram fuel filters and has no relation to any original equipment installed on the vehicles listed.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

• Throttle sticking/binding investigation # EA93012

  There is no summary currently available
  

  Show Content

While driving 15 mph, the brake lines rusted. As a result, the brake pedal proceeded to the floor and brake fluid came out of the brake line. No impact reported. The consumer stated that the brake line should be made out of stainless steel. Please provide additional information. *jb

I was driving along the highway and the vehicle suddenly cut off i loss power the vehicle came to a stop. I believe this was due to an ignition switch problem. I had the car towed to my home in macon county,alabama. The car was later stolen from my home address of 401 boyd road shorter,alabama 36075. The incident was reported to the macon county, sheriffs department.

Front disc brake pad bonding to brake pad backing plate failed causing pad to fail in shear.*ak

Driver's side belt buckle will not latch. Dealer notified, and informed consumer that was not covered under a recall, and any repairs would be at consumer's cost. *ak

Peoo 020; consumer was traveling 40mph on highway and heard a banging noise, left rear tire tread separated, and it tore a hole though the bottom of vehicle. Tire was flat. Firestone, bridgestone, size P21575 sr15. Consumer contacted firstone, and they told consumer to take it back to where he bought it from. *ak bridgestone/firestone p215/75/r15 *mw

Car experienced an uncommanded full throttle acceleration, resulting in an accident with my other vehicle. *ak

Power switch that controlled the seats overheated and then a fire started on the front right side of door area. *ak

When stopped at gas station inserted the gas pump nozzle not into fuel tank nozzle, but instead inserted the gas pump nozzle in one of the spaces and pumped gas onto the ground. *ak

Brakes inadequate for the size of vehicle.

Common OBD-II Error Codes

• P2157 [1] Fuel Injector Group "D" Supply Voltage Circuit High