Use the box here to look up VINs from CRANE as well as other manufacturers
Frequently Asked Questions
Where is the 2003 CRANE Let2 produced?
- The 2003 CRANE Let2 is produced in New Philadelphia Ohio, United States (usa).
Are there recalls for the 2003 CRANE Let2?
- There are 4 recall(s) for the 2003 CRANE Let2, additional information is below.
NHTSA Mandated Recalls
Recall 72642 [USA]: This standard specifies performance and equipment requirements for vehicles equipped with air brake systems, including air-over-hydraulic brake systems, to ensure safe braking performance under normal and emergency conditions.
Crane carrier is recalling 672 my 1999-2001 coe,my 1999-2002 ldt, my 2001-2007 ldt2, my 1998-2003 let, and my 2001-2007 let2 refuse cab and chassis for failing to comply with the brake release timing requirements of federal motor vehicle safety standard no. 121, "air brake systems." the brake release timing was slower than required. crane will replace several fittings and hoses which will increase the air flow and subsequently improve the brake release timing. The recall began on march 14, 2008. Owners may contact crane carrier at 918-832-7305. customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.
Recall 42292 [USA]: If the wheels are not identified and replaced a sudden failure of the wheel may occur without warning possibly resulting in a vehicle crash which could cause serious injury or even death.
On certain vehicles equipped with galaxy disc truck wheels, size 22.5" x 9", a failure of these wheels can occur. galaxy is handling all owner notification and remedy for this campaign. Galaxy will notify its customers and replace the wheels. Owners should contact galaxy tire at 1-800-343-3276 or crane at 1-918-836-1651. customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
Recall 34975 [USA]: If this event occurs, the vehicle operator will not have control of the engine speed which could possibly result in a vehicle crash.
On certain heavy duty trucks equipped with cummins westport b gas plus or c gas plus 6 cylinder engines, the electronic control module calibration may not correctly detect a throttle plate actuator failure that could result in an uncommanded open throttle condition. both units have already had the electronic control module calibration replaced. also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
Recall 33428 [USA]: If this occurs, braking performance will be inhibited, increasing the risk of a crash without warning.
On certain trailers equipped with a specific combination of reyco suspension, eaton drive axle, and bendix slack adjusters, the failure of a drive axle slack adjuster to automatically adjust as required to compensate for brake wear, will cause an out of adjustment condition. If this condition occurs and is not identified and corrected through normal inspections and maintenance, the slack adjuster will over-rotate and may contact the suspension lower spring saddle. crane carrier will supply, at no charge, gunite slack adjusters and installation instructions to replace the existing bendix slack adjusters on the drive axle. The installing facility will be reimbursed by crane for one (1) hour labor per vehicle at their posted labor rate. Owner notification began on june 10, 2003. Owners should contact crane at 1-918-832-7305. customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.