Ford Mustang 1984

• Recall 71962 [USA]: A leaking fuel pump could create a vehicle fire hazard.
  Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, napa, truflow, parts depo, and parts master, shipped between august 2006 and july 2007 for use on the vehicles listed above. The fuel pump diaphragm in certain production runs may have been improperly installed or inadequately tested which may cause the fuel pump to leak.
  federal-mogul will notify owners and replace the defective fuel pumps free of charge. The recall began on october 15, 2007. Owners can contact federal-mogul at 248-354-7700.
  this recall only pertains to aftermarket carter, napa, accuflow, tru flow, parts master, and parts depot brand fuel pumps and has no relation to any original equipment installed on the listed motor vehicles.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 21565 [USA]: If the tongue detaches from the safety belt webbing, thesafety belt would not attach to itself, resulting in increased risk of injuryto the seat occupant in the event of a sudden stop or vehicle crash.
  The plastic sleeve in the front safety belt tongue assembly which retains the lock bar can deteriorate from prolonged exposure to sunlight and become displaced, causing the tongue to detach from the safety belt webbing.
  ford will repair the safety belts experiencing this condition regardless of vehicle age or condition.
  system: safety belts.Vehicle description: passenger cars.

  Show Content

• Recall 30153 [USA]: Consequence of defect: this sticking could result in a faster speed than intended, possibly resutling in an accident.
  The secondary throttle shaft may, with accumulated mileage, become contaminated and may stick in a partially open position while driving.
  the primary to secondary throttle closure link on the carburetor will be replaced free of charge.
  vehicle description: passenger vehicles equipped with 5.0 liter engines, and trucks and multipurpose passenger vehicles equipped with 5.8 or 7.5 liter engines; vehicles are equipped with 4 barrel carburetors.System: fuel; carburetor secondary throttle control.

  Show Content

• Recall 30320 [USA]: Vehicle description: passenger vehicles and light trucks.system: interior systems; seat belts and upper torso restraint attach
  The bolts that attach the d-shaped ring for the shoulder belt are inadequately supported by the material in which they are mounted. The attachment does not comply with the requirements of federal motor vehicle safety standard no. 210, "seat belt assembly anchorages".
  dealers will install new attaching hardware to improve the strength of the mounting.
  vehicle description: passenger vehicles and light trucks.System: interior systems; seat belts and upper torso restraint attachments.Consequences of defect: in severe collisions, the shoulder belt attachmentcould separate, increasing the possibility of occupant injury.Note: manufacturer advises that seat belts should continue to be used at alltimes, as substantial benefits may still be obtained.

  Show Content

• Recall 1992117 [Canada]: Seats and restraints
  Prolonged exposure to sunlight may cause the front seat belt tongue assembly plastic sleeve that retains the lock bar to deteriorate and become displaced. This could potentially result in the tongue becoming detached from the seat belt webbing making the seatbelt useless to the vehicle occupant. Correction: owners will be advised that ford will repair seat belts experiencing this condition.

  Show Content

• Recall 1984117 [Canada]: Carburetor throttle shafts may be susceptible to dirt contamination and wear of the bearing coatings. this could cause the sec
  Carburetor throttle shafts may be susceptible to dirt contamination and wear of the bearing coatings. This could cause the secondary throttle plates to remain partially open after the driver has released the accelerator pedal. This this were to occur, engine speed would not return to idle potentially affecting vehicle control and stopping distances.

  Show Content

• Recall 1983114 [Canada]: The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated fr
  The upper torso restraint d-ring which attaches the shoulder belt to the b pillar, under certain test conditions, separated from its anchorage, and may not comply with cmvss 210 - belt anchorage.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Safety belt tongue breaks investigation # EA91003

  There is no summary currently available
  

  Show Content

• Seat belt latch assembly investigation # PE88096

  There is no summary currently available
  

  Show Content

• Stalling investigation # PE87028

  No safety defect trend has been detected.===
  

  Show Content

• Seatback failure investigation # EA86010

  Summary of information from manufacturer:ford believes that the al-leged defect only occurs in a small number of the subject vehicles andrecalled about 195,732 1984 tempo/topaz vehicles in june 1986.Analysis: vehicles potentially involved include tempo/topaz, escort/lynx/exp, mustang/capri, ltd/marquis, and thunderbird/cougar.Ford sold about 110,000 replacement mio bolts, mainly for 1983 and 1984models. Low clamping force appears to be a large part of the problem.Ford increased the torque requirements and required the use of a manualtorque tool in march and september 1985 production changes. 1987 modelswill be produced with a longer m10 bolt and a nut to increase and main-tain clamping force. Bolts were formerly self tapping. Reports listedabove specifically state that the bolt broke. None refer simply toseat back collapse alone.Status:ford reply to odi ir dated 2/2/87.Ford recalled 195,7321984 tempo/topaz vehicles in june 1986 (86v-082). Analyzing reponse,monitoring canadian progress. Response to 4/6/87 letter to fordreceived 7/15/87. Will probably close after canada completes theiractions.===
  

  Show Content

Ignition module failed prior to recall.Also replaced thermostat and heater hose.

Two left and right pads were excessively worn, broken in numerous locations and were disntegrating after 4k miles of operation.

Ignition switch overheated, smell of smoke in interior, could cause fire. *ak

Vehicle stalls while driving.Owner received no indication that vehicle was going to stall. When the vehicle would warm up it, would stall. The dealer has been notified. *ak

Seat belt came apart in accident.

Vehicle stalls while driving at hwy speeds, computer modules has been replaced three times. *ak

After shutting off, vehicle caught on fire. Fort myers city fire dept., electrical failure cause of fire. Please describe details.

(used)vehicle caught on fire round about the center of vehicle in the area of the steering column when starting up the vehicle. Please give more details. *ak

Tail pipe rusted/fell off.