GMC T-SERIESGmc T-series

Vehicle Details: Service Bulletins

Below you will find all available information on the GMC T-SERIES.

ManufacturerKnown WMI(s)Fuel Type
GMC
GMC VIN Decoder

Use the box here to look up VINs from GMC as well as other manufacturers

#
NHTSA Mandated Recalls

No recalls could be found for this vehicle. To ensure accuracy and for your safety, do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • N212328980 - ELECTRICAL SYSTEM: Service update bulletin. The affected vehicles may have a condition where the rear fuse block cover diagram has incorrect fuse values. Dealers are to add an adhesive label to the rear fuse box cover.
  • N192291100 - AIR BAGS: Special coverage. Some vehicles equipped with a 2.4l engine (rpo lea) may exhibit excessive engine oil consumption (less than 2,000 miles [3,200 km] per quart [0.946 l] of engine oil), due to piston ring wear. If this condition is present,
  • IB10X001E - FUEL SYSTEM, OTHER:FUEL FILTER: This bulletin is being issued to inform dealers of diesel particulate filter (dpf) cleaning recommendations, inspection practices, and recommended r&r procedures for service and cleaning system availability.
  • IB16-J-002 - ENGINE (PWS): Isuzu motors limited has analyzed failed engines and determined that engine oil diluted with diesel fuel is a cause of some engine failures. If the engine oil level is high, the oil may be diluted with diesel fuel. This bulletin is being is
  • IB09-X-001L - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : In order to improve the quality of the original equipment manufacturer (oem) and service replacement engines and transmission assemblies, the isuzu quality center (iqc) is being implemented to assist dealers whenever an isuzu diesel/gasol
  • IB09-X-001K - ENGINE (PWS): In order to improve the quality of the original equipment manufacturer (oem) and service replacement engines and transmission assemblies, the isuzu quality center (iqc) was implemented to assist dealers whenever an isuzu diesel/gasoline eng
  • IB12-J-003C - ENGINE (PWS): Proper installation of the fuel injector pipes into a long block assembly. The fuel injection pipes should be installed onto the new long block assembly after first installing the common rail. When installing the fuel injection pipes, fol
  • IB16-H-001 - BRAKES (PWS): Isuzu commercial truck of america is sending this bulletin to remind dealers to strictly follow the procedures set forth in the shop manuals when conducting brake inspections or brake repairs, including replacing brake pads, on isuzu trucks
  • PI-0281-E - EQUIPMENT: This preliminary informational bulletin provides information that may be helpful when addressing underbody component corrosion with customers.
  • SB-03-07-29-004K - POWER TRAIN:MANUAL TRANSMISSION: This informational bulletin provide information on the operating characteristics of a manual transmission.
  • PIT-4838 - ENGINE AND ENGINE COOLING:ENGINE: Gmc/chevrolet: in rare cases when ignition key is turned off the engine continues to run. This could be caused by a voltage back feed through the a/c-wiper diode on kodiak/topkick t series trucks. (remove diode) *pe
  • 010101 - UNKNOWN OR OTHER: Subject regarding new body ltg correction, there is an incorrect time for engine replacement. *slc

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.