Harley-davidson Flhtc 2007

No recalls could be found for this vehicle. To ensure accuracy and for your safety, do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

Tl* the contact owns a 2007 harley-davidson flhtc. While riding 75-80 mph, an abnormal noise emitted from the transmission. The dealer diagnosed that the transmission needed to be replaced. The motorcycle was repaired. The manufacturer was notified of the failure. The approximate failure mileage was 60,000. Updated 04/06/17 lj *tr

The rear brake line (pn 40971-00a) rubbed the frame and clutch cable, causing a hole to be created. This is in the area below the cam chest, behind the master cylinder, inside the frame on the right side. The brake line blew out when the rear brake was applied. There was no warning. After doing research, i found this to be a common problem. *tr

Tl* the contact owns a 2007 harley davidson flhtc. The contact stated that while driving at 9 mph, the brake lamp failed to activate when the brake pedal was depressed. The contact mentioned that the brake lamp switch was melted. The vehicle was taken to a dealer where it was diagnosed that the brake light switch needed to be replaced. The vehicle was not repaired. The manufacturer was notified of the failure and stated that the vin number was not included in nhtsa campaign number: 11v506000 (exterior lighting). The failure mileage was 43,000.

As i was slowing down in my driveway the engine, with out warning, made a loud metallic noise from the left side and locked up along with the rear wheel. If this would have happened at a greater speed, or in traffic, the consequences could have been dire. I removed the primary cover and immediately notice a large piece of steel had gotten jammed between the clutch sprocket and primary drive chain. This large piece of steel had broken off a pressed steel cage that enclosed a set of diaphragm springs from the crankshaft compensator assembly. The outer edge of the springs, over time, had worn their way through the cage that contains them in place causing a section of the cage to separate. This separated piece is what caused the engine and drive train to lock up. I have an engineering back ground and can say that this compensating sprocket assembly was poorly engineered and can also say with great amount of certainty that they will all fail eventually. I am very surprised that this was never a safety recall considering all the owners who have had problems with this assembly. All one has to do is google "harley compensator problems" and it finds a huge amount of info on this! *tr

When switch to high beam all lights go out because the 15 amp fuse will blow. *tr

Tl*the contact owns a 2007 harley davidson flhtc motorcycle. The contact stated his exhaust pipe turned red after overheating. The over heating is caused by the exhaust pipe and cylinder head. The dealer is waiting for approval from the regional manager to make the repairs. The failure mileage was 2,800.

My 2007 flhtc harley davidson has been a lemon since i bought it in 2007. The bike always runs hot due to the fact there is no oil pressure at times. The cpk unit went out and leaked oil everywhere after one month. The front part of this unit, which was inside the motor, was damaged. The dealership said something had to have hit it. Instead of tearing down the motor to find out what hit it they just replaced it. Oil pressure constantly drops after riding for awhile. The dealership said that was normal. Now the bike has no oil pressure and is leaking oil from somewhere. It is back at the dealership being worked on again. I do not trust this bike to go anywhere far from home. Something is wrong with either the oil pump or the way oil is circulated. You have to look while riding to see if oil is leaking from somewhere. If the motor locks up from lack of oil the bike will be past dangerous. Oil pump alignment has been mentioned on web sites as the problem. Harley will not stand behind fixing this bike correctly. There needs to be a recall. *tr

Purchased a 2007 ultra classic electra glide harley davidson on july 27. I had to return the bike this week and get my money back. This model has a heat problem which harley davidson and the dealers are aware of, they are selling these and not letting the consumer know about it. Once you are aware of this, they don't know how to solve it but they will change some things at your expense. I paid alot of money for this, not intending to go home and have to change it right away. The pipe under the seat gets so hot that it glows bright red. It burnt the passengers leg. After i complained enough, they agreed to take it back and return my money. They say that the 2008 models have the same problem. Why let them sell these? It's a shame because i have eight other harley's in my garage. The dealers are saying that the epa won't let them fix this problem and if the consumer fixes it, he is facing a $10,000 fine. What's wrong with this picture? *tr

I have a 2007 harley davidson electra glide. There is an excessive amount of noise and vibration that comes from the transmission in 5th and 6th gear. I put in heavy 75-90 gear oil and it got a little quieter. Now it seems hd has put in an isolated drive system in there 08 touring models as standard equipment. You can purchase the unit for $305.00 plus labor to put on the 07 touring models. Harley davidson knew they had a problem with the 07 transmission, fixed it on the 08 but want the consumer of an 07 to pay for the part and there mistake. *tr

Common OBD-II Error Codes

• B1146 [1] B1146
• B1100 [1] B1100