Harley-davidson Fltr 2008
Vehicle Details: Recalls, Investigations, Consumer Complaints, Decoded VIN Details, Service Bulletins
Below you will find all available information on the 2008 HARLEY-DAVIDSON Fltr.
The vehicle is described as a Two Wheel Motorcycle (excluding motor scooters).
Manufacturer | Known WMI(s) | Fuel Type |
---|---|---|
HARLEY-DAVIDSON | Gasoline |
Use the box here to look up VINs from HARLEY-DAVIDSON as well as other manufacturers
Sub-models: - Fltr / Road Glide -
-
Where is the 2008 HARLEY-DAVIDSON Fltr produced?
- The 2008 HARLEY-DAVIDSON Fltr is produced in York Pennsylvania, United States (usa).
-
Are there recalls for the 2008 HARLEY-DAVIDSON Fltr?
- There are 3 recall(s) for the 2008 HARLEY-DAVIDSON Fltr, additional information is below.
-
What is the GVWR of a 2008 HARLEY-DAVIDSON Fltr?
- The 2008 HARLEY-DAVIDSON Fltr has a GVWR of Class 1A: 3,000 lb or less (1,360 kg or less) lbs.
-
How much horsepower does the 2008 HARLEY-DAVIDSON Fltr have?
- The 2008 HARLEY-DAVIDSON Fltr has 71 horsepower.
Recall 129644 [USA]: These deposits may cause a valve within the abs hydraulic control unit to stick, reducing braking ability and increasing the risk of a crash.
Recall 78554 [USA]: This condition could lead to a crash which could cause injury or death to the rider.
Recall RM/2009/027 [UK]: Wheel may crack
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- M1612 - ENGINE AND ENGINE COOLING: Service bulletin m1612 (rev a): milwaukee-eight and twin cam transmission gear packs. Purpose: revision. Update: notes for table 3 and 4. * updated: part numbers. This bulletin informs dealers that all: twin cam gear packs on cvo, dyna, po
- PAB1146 - EXTERIOR LIGHTING: Genuine motor parts and motor accessories bulletin paB1146: 68193-95 bulb wedge, fender tip lamp. Purpose: to inform dealers of an issue with the bulb wire terminals not being to specification. The light bulbs were used in numerous front an
- M1612 - POWER TRAIN: Service bulletin m1612: milwaukee-eight and twin cam transmission gear packs. Purpose: this bulletin informs dealers that all: ??A?A? Twin cam gear packs on cvo, dyna, police, softail, touring & trike models and ??A?A? Milwaukee-eight gear
- M1612 - POWER TRAIN: Service bulletin m1612: milwaukee-eight and twin cam transmission gear packs. Purpose: this bulletin informs dealers that all: a?? Twin cam gear packs on cvo, dyna, police, softail, touring & trike models and a?? Milwaukee-eight gear packs
- PAB1100 - ENGINE AND ENGINE COOLING: Genuine motor parts and motor accessories bulletin paB1100: twin cam longblock & warranty engine - program updates. Purpose: to inform dealers of certain twin cam longblock and twin cam warranty engines are no longer supported. Instead, sho
Motorcycle stalling investigation # PE08043
The subject fuel filter housing (p/n 62229-08) cracks, resulting in sudden engine stall due to unregulated fuel pressure.Harley-davidson has modified the housing with a new part number 62229-08a.Shortly after opening this pe, odi received harleys defect notification indicating that the subject vehicles were being recalled to install the new fuel filter housing.With that recall, received prior to release of our information request, this investigation is concluded.
138 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.
Variable | Value |
---|---|
Body Class | Motorcycle - Touring / Sport Touring |
Cooling Type | Air |
Destination Market | 49 States (Except California) |
DisplacementCC | 1584 |
DisplacementCI | 96.661610646 |
DisplacementL | 1.584000 |
Engine Cycles | 4 |
Engine Cylinders | 2 |
EngineHP | 71 |
EngineKW | 52.9447 |
Engine Model | Twin CAM 96 V-2 |
Error Text | 0 - VIN decoded clean. Check Digit (9th position) is correct |
Fuel Injection Type | Sequential Fuel Injection (SFI) |
Fuel Type Primary | Gasoline |
GVWR | Class 1A: 3,000 lb or less (1,360 kg or less) |
Make | HARLEY DAVIDSON |
MakeID | 3888 |
Manufacturer | HARLEY-DAVIDSON MOTOR COMPANY |
Manufacturer Id | 4249 |
Model | FLTR / Road Glide |
ModelID | 11573 |
Model Year | 2008 |
NCSA Body Type | Two Wheel Motorcycle (excluding motor scooters) |
NCSA Make | Harley-Davidson |
NCSA Model | 750cc or greater |
Note | Normal introduction |
Other Motorcycle Info | Heavyweight Motorcycle: 901cc or larger |
Plant City | YORK |
Plant Country | UNITED STATES (USA) |
Plant State | PENNSYLVANIA |
VIN | 1HD1FS4138Y686788 |
Vehicle Type | MOTORCYCLE |
Crash | Fire | Towed | Injured | Deaths | Failure Date |
---|
No | No | N | None | None | 20190330 |
While riding on 3/31/2018 i was approaching a stoplight and began my down shifting and braking. I stepped on the rear brake pedal and to my surprise there was little resistance, i pumped the pedal again only to have the same result. I then pumped the pedal several times noting same result as previous attempts but was able to stop using my front brake. We pulled off into a gas station parking lot to assess the problem. Upon inspection, i found one of two wires (red) on the rear brakelite switch sensor had melted off from the switch an was lying next to the switch sensor and fluid had leaked/sprayed out covering the surrounding area. Looking more closely, i found that the brass terminal post of the switch had melted off the switch housing and was still lodged within the wire connector. I recalled this happening to a relative a few years ago and in researching the issue through forums and general online research, i found there are several cases regarding this problem and even a recall (harley davidson recall 0145) which only covered 2009-2011. This safety issue obviously applies to the 2008 model fltri as well and should have been included.
No | No | N | None | None | 20180703 |
Tl* the contact owns a 2008 harley-davidson road glide (fltr). While riding at various speeds, the throttle body sensor failed. As a result, the vehicle stalled and lost power without warning. The contacted pulled over, restarted the vehicle, and resumed normal riding. When the failure recurred, the contact towed the vehicle to baer sport center harley-davidson and polaris (330 grandview ave, honesdale, pa 18431, (570) 253-2000) where they replaced the plugs on the throttle body. The failure recurred. The contact took the vehicle to other unknown harley-davidson dealers to have the vehicle serviced, but the failure persisted each time. The manufacturer was notified of the failure and referred the contact to nhtsa to file a complaint. The vehicle was not repaired. The failure mileage was unknown.
No | No | N | None | None | 20171129 |
Front brakes failed due to bad abs module with no warning. Very hard to pull in when trying to stop. Worked fine and now nothing. This could have resulted in myself wrecking (rear ending) someone if it happened a busy road.
No | No | N | None | None | 20170514 |
Tl* the contact owns a 2008 harley-davidson fltr. While driving 5-65 mph, the rear brakes seized several times without warning. The vehicle was taken to the dealer (fort worth harley-davidson, 3025 w loop 820 s, fort worth, tx 76116, (817) 717-4325) for diagnostic testing and repair. Months later, the contact was notified of nhtsa campaign number: 18v076000 (electronic stability control) by email. The manufacturer was notified of the failure and the contact called to determine the recall solution to repair the motorcycle. The approximate failure mileage was 50,000. *tt *tr
No | No | N | None | None | 20161216 |
Front brake abs system hcu failure resulting in loss of front brake function
Crash | No | Y | 1 Injured | None | 20160721 |
Tl* the contact owned a 2008 harley-davidson fltr road glide. Whiledriving approximately10 mph, the brake pedalwas depressed,but the vehicle failed to respond without warning. As a result,the contact sideswiped another vehicle and crashed into an aluminum bridge.A police report was filed. The contact sustained injuries to the left arm, left forearm, left knee, and ankles that required medical attention. The vehicle was towed to a dealer, but was not diagnosed or repaired. The vehicle was destroyed. The manufacturer was notified of the failure. The failure mileage was 36,000.
No | No | N | None | None | 20160514 |
Tl* the contact owns a 2008 harley-davidson fltr road glide. When the brake pedal was depressed, the brakes failed to stop the vehicle. The contact had to apply the emergency brake to stop. There were no warning indicators illuminated. The vehicle was not diagnosed or repaired. The manufacturer was notified of the failure, but did not offer assistance. The failure mileage was 50.
No | No | N | None | None | 20160414 |
The abs module on my bike has quit working. With the ignition on the module closes and the front brakes cannot be applied. If this were to happen while riding, a crash would be inevitable. The module should be designed so that there is an emergency bypass in the event the internals inside the module becomes stuck so that the rider is not suddenly without brakes. Harley davidson should issue an immediate recall.
No | No | N | None | None | 20130720 |
The passenger floorboard/footboard mounting bolt is prone to sheer off. This ejects the 10-15 pound part from the motorcycle causing a serious safety hazard. This is a common occurrence and even though the part was redesigned in 2010 to include 2 mounting bolts the harley davidson corporation has denied that there is a problem with the earlier single mount bolt design. *tr
Common OBD-II Error Codes
VIN | Year | Model | Manufactured In |
---|---|---|---|
1HD1FS4148Y647319 | 2008 | FLTR / Road Glide | YORK PENNSYLVANIA, UNITED STATES (USA) |
1HD1FS4138Y686788 | 2008 | FLTR / Road Glide | YORK PENNSYLVANIA, UNITED STATES (USA) |
1HD1FS4198Y611268 | 2008 | FLTR / Road Glide | YORK PENNSYLVANIA, UNITED STATES (USA) |