Use the box here to look up VINs from HONDA as well as other manufacturers
NHTSA Mandated Recalls
Recall R/2019/243 [UK]: Possible air bag inflator rupture
Passenger air bag may not deploy correctly. the inflator inside the passenger?S airbag module is to be replaced.
Recall R/2004/034 [UK]: Low beam headlights may not operate.
Dipped beam headlights may malfunction either when switched on or during driving. recall likely to be affected vehicles and replace the headlight switch with a modified part. Additionally the terminal for dipped beam operation within the wiring harness will also be changed in order to rectify any heat damage that may have occurred.
Recall R/2013/049 [UK]: Passenger side airbag may fail to deploy correctly
The subject vehicles are equipped with front passenger airbag inflators which could have been assembled with improperly manufactured propellant wafers. Improperly manufactured propellant wafers could cause the inflator to rupture and the front passenger airbag to deploy abnormally in a crash. This could result in increased risk of injury to the occupant or in a thermal issue in the interior compartment which may lead to fire. recall the vehicles that are likely to be affected to inspect and where necessary replace the airbag inflator module.
Recall R/2010/007 [UK]: Risk of fire
Water and other liquids may enter the driver's side power window switch and may cause damage switch failure overheating and potentially a fire. recall affected vehicles check switch and wiring if damaged replace and then fit external cover to switch to prevent water ingress.
Recall R/2010/228 [UK]: Headlights may not illuminate correctly
Due to the layout of the lighting switch wiring harness the low beam headlight circuit can be pulled tighter than other wires. After repeated use of the headlight switch the low beam terminal can become worn and poor electrical continuity may result from an accumulation of copper oxide. In some cases the poor continuity the poor continuity or melted terminal ends will cause the wiring harness terminal ends to melt. Poor continuity or melted terminal ends will cause the low beam head lights to become inoperative increasing the risk of accident. the dealer will inspect the low beam terminal if the terminal shows signs of melting the lighting switch and low beam terminal harness will be replaced. If the terminal is not melted the low beam terminal harness will be replaced.
Recall R/2013/076 [UK]: Risk of fire
Water and other liquids may enter the driver's side power window switch and may cause damage switch failure overheating and potentially a fire. recall affected vehicles and replace driver's side power window switch.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Honda Jazz 2001