International 9100 1998

• Recall 2001124 [Canada]: Brakes
  On certain vehicles, the automatic slack adjuster anchor brackets can fail due to fatigue fracture and completely separate, causing the slack adjusters to function as manual slack adjusters. If the support bracket for an automatic slack adjuster fails, the brakes at that wheel end will not automatically adjust. As the brake linings wear, the vehicle will have reduced braking capacity, increasing the risk of a crash. Correction: dealers will install a new bracket on each suspect slack adjuster.

  Show Content

• Recall 1998065 [Canada]: Brakes
  Note: vehicles equipped with caterpillar c10 and c12 engines. A p-clamp and bracket required to support the compressor discharge line was not installed at the rear of the engine on these vehicles. A failed compressor discharge line could deplete the air system and could cause the parking brakes to apply. This could result in the vehicle slowing down or stopping unexpectedly. Correction: p-clamp and bracket will be installed at the rear of the engine on affected vehicles.

  Show Content

• Recall 1998223 [Canada]: Powertrain
  Certain vehicles may have experienced loosening of the end yoke retaining nut. If this condition occurs, the driveline can vibrate and separate from the vehicle, causing vehicle damage or personal injury or both. Correction: center bearing package and coupler shaft will be replaced with a new coupler shaft and a 60mm center bearing package.

  Show Content

• Recall 2004074 [Canada]: Electrical
  On certain vehicles, water intrusion into the sleeper berth's bunk control panel area may pool in the tops of the dome light, tv/vcr, and/or refrigerator power switches. The led circuit boards in these switches may begin to heat up and possibly produce a flame or fire, without warning, that could cause property damage, personal injury, or death. Correction: dealer will install a water shield over the back of the entire bunk control panel.

  Show Content

• Recall 2003134 [Canada]: Other
  On certain vehicles, a defect in the front wheel hub bearings will result in premature spalling which will lead to eventual breakdown of the bearing. An early breakdown of the wheel hub bearing system, when undetected, can possibly cause a wheel fire, wheel separation, loss of vehicle control, or vehicle fire. Correction: dealer will replace front axle hubs.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.