Jeep Grand Cherokee 1992

• Recall R/2001/166 [UK]: Front brake rotors (discs) may fail.
  There is a possibility that corrosion may cause the front brake rotors (discs) to separate from the centre hub section. Vehicle may pull to one side when braking. Also braking efficiency will be reduced.
  recall affected vehicles for inspection and if necessary replacement of both front brake rotors with new version. ( note. Some vehicles will already have the new version fitted)

  Show Content

• Recall R/2013/093 [UK]: Risk of fire
  If the vehicle is involved in a rear end collision then it is possible that the fuel tank could be damaged. This can then result in a fuel leak which if in the presence of an ignition source then a vehicle fire could ensue.
  

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Sudden acceleration investigation # DP02005

  There is no summary currently available
  

  Show Content

• Brake roter disc/hud separation investigation # EA99014

  There is no summary currently available
  

  Show Content

• Brake disc/hub separation investigation # EA97001

  Consumer complaints indicate that corrosion of the brake rotors have caused separation of the brake disc from its hub, resulting in brake failure.
  

  Show Content

• Safety blt latch operation investigation # PE96008

  There is no summary currently available
  

  Show Content

• Rear axle shaft separation investigation # PE95049

  This investigation was opened to examine the failure mode and the risk to motor vehicle safety posed by allegations of rear axle separations.The rear axle shaft and housing design is typical of those in which the weight of the vehicle is carried on the axle housing.The left and right axle shafts, supported by roller bearings, are situated inside the axle housing.The inboard splined end of the axle shaft receives power transmitted from the differential assembly, providing torque to the rear wheels.The allegations are that the axle shaft fails, resulting in the separation of a wheel and axle hub assembly or the entire axle shaft and wheel assembly, depending on the location of the axle shaft failure.As identified by chrysler, the subject rear axles are dana 35c and 35cm models, which have been used on the subject vehicles since the 1990 model year.A safety defect trend with respect to the subject axle shafts has not been identified.See hard copy resume for full text of summary.
  

  Show Content

Consumer called complaining about the manifold intake been broken. Also stated that dealer was contacted and stated that it is a common problem with the model of vehicle and also said that will only charging the consumer for it because there is no recalls or warranty for the vehicle. Ts

Consumer called complaining about having problems with the intake manifold. Also stated that dealer was contacted and stated that the intake manifold was broken and that they are aware of the problem with the model and year but at the same time there is nothing they can do about it because there is no recalls. *nlm

Vehicle was sitting in driveway when motor started to accelerate. Then, vehicle jumped out of gear and went into reverse. Vehicle jumped a fense, and hit a wall. Consumer has yet to contact dealer. Please provide any further information.*ak