Jeep Wagoneer 1993
Vehicle Details: Investigations, Consumer Complaints, Service Bulletins
Use the box here to look up VINs from JEEP as well as other manufacturers
-
Where is the 1993 JEEP Wagoneer produced?
- The 1993 JEEP Wagoneer is produced in AUBURN HILLS Mi, United States (usa).
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- R2118796A - ENGINE AND ENGINE COOLING: Valve body. These may cause over drive cycling.
- 0800600REV - ELECTRICAL SYSTEM: Subject regarding wire splice repairs. *sb
- 2300800B - SEATS: Subject regarding child seat tether anchors. *tt
- 233599REVA - STRUCTURE:BODY: Subject on the child seat tether anchors. *mjs
- 230800 - SEATS: Subject regarding child seat tether anchors. *tt
- 080600 - ELECTRICAL SYSTEM:WIRING: This bulletin provides a revised wire splice procedure and related parts. *tt
- 233599 - SEATS: Information on child seat tether anchors. *tt
- 081698 - EQUIPMENT:ELECTRICAL:RADIO/TAPE DECK/CD ETC.: Information on installation of radio transmitting equipment. *ak
- 230397 - STRUCTURE:FRAME AND MEMBERS: Difficult to clean light colored "chalky" residue from plastic body components that are molded in black. *tw
- 081695REVA - VEHICLE SPEED CONTROL: Bulletin supersedes technical service bulletin 08-16-95, dated apr. 14, 1995. If the vehicle operator **repeatedly** presses and releases the set button with their foot off of the accelerator (a 'lift foot set' to begin speed control oper
Rear axle shaft separation investigation # PE95049
This investigation was opened to examine the failure mode and the risk to motor vehicle safety posed by allegations of rear axle separations.The rear axle shaft and housing design is typical of those in which the weight of the vehicle is carried on the axle housing.The left and right axle shafts, supported by roller bearings, are situated inside the axle housing.The inboard splined end of the axle shaft receives power transmitted from the differential assembly, providing torque to the rear wheels.The allegations are that the axle shaft fails, resulting in the separation of a wheel and axle hub assembly or the entire axle shaft and wheel assembly, depending on the location of the axle shaft failure.As identified by chrysler, the subject rear axles are dana 35c and 35cm models, which have been used on the subject vehicles since the 1990 model year.A safety defect trend with respect to the subject axle shafts has not been identified.See hard copy resume for full text of summary.
| Crash | Fire | Towed | Injured | Deaths | Failure Date |
|---|
| No | No | N | None | None | 19980826 |
The defective door mechanism broke, causing driver's door not close properly, could cause occupant may fall out of the vehicle. Dealer claims this is a current problem. Please provide details. *ak
| No | No | N | None | None | 19970628 |
Intake manifold failed, causng oil leak.
| No | No | N | None | None | 19950424 |
Muffler repaired. *aw
| No | No | N | None | None | 19931031 |
Continuous oil leak. *aw
| No | No | N | None | None |
Transmission replaced due to continuous fluid leak, also shuddered in overdrive.