Kenworth T800 2003

• Recall 32856 [USA]: If any of these conditions exists, the transmission will not automatically shift into neutral when left in drive with the parking brake set engaged. the vehicle could move without warning increasing the risk of a crash.
  On certain trucks, the wiring, parts, or transmission programming required for the auto neutral feature to function as designed were either not installed, connected, or programmed properly.
  dealers will inspect the affected vehicles to ensure the auto neutral feature functions properly and, if needed, will make the necessary repairs free of charge. The recall began on may 9, 2007. Owners may contact kenworth at 425-828-5440.
  kenworth recall no. 07kw3.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 35007 [USA]: This could cause the neutral start feature of the transmission to disable allowing the vehicle to start in gear increasing the potential for a crash.
  Certain trucks equipped with eaton fuller ultrasonic transmissions fail to comply with the requirements of federal motor vehicle safety standard no. 102, "transmission shift lever sequence, starter interlock and transmission braking effect." the cab transmission harness could have been incorrectly wired during production installation.
  dealers will repair the connections in the wiring harness if necessary. Owner notification began on may 7, 2004. Owners should contact kenworth at 1-425-828-5440.
  kenworth recall no. 04kw1.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 56841 [USA]: Kenworth recall no. 03kw7.customers can also contact the national highway traffic safety administration's auto safety hotline
  On certain heavy duty trucks, the main cab wiring harness was incorrectly connected to the 50 amp circuit breaker instead of the 135 amp breaker.
  dealers will inspect the vehicles and the wiring will be corrected if necessary. Owner notification began september 16, 2003. Owners should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw7.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 35435 [USA]: This condition could cause a person to slip and/or fall and could lead to personal injury.
  On certain heavy duty trucks equipped with vertical tail pipes, the frame access grabhandle is mounted too high.
  dealers will inspect the grabhandle location and if determined to be mounted too high, the handle will be relocated to the proper height. Owner notification began july 29, 2003. Owners should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw5.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 34147 [USA]: If left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
  On certain trucks equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
  dealers will replace the bracket pins and repair instructions free of charge. Peterbilt's owner notification began june 20, 2003. Kenworth's owner notification began june 12, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.
  peterbilt recall no. 403-c/kenworth recall no. 03kw4.Also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 57596 [USA]: This does not meet the requirements of the standard.
  Certain trucks equipped with meritor p 18x7 brakes with 36" brake chambers fail to comply with the requirements of federal motor vehicle safety standard (fmvss) no. 121, "air brake systems." these trucks were manufactured with a combined air reservoir volume less than 12 times the combined volume of all service brake chambers.
  dealers will add an additional tank or change one of the existing air tanks to a larger size. Owner notification began on may 5, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw3. Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 54829 [USA]: This could cause an electrical short and/or possible fire hazard.
  Certain trucks equipped with trailer connections fail to comply with the requirements of federal motor vehicle safety standards (fmvss) no. 121, "air brake systems," and no. 108, "lamps, reflective devices, and associated equipment." the supplier removed a rubber grommet from the trailer light line connector. The vehicles are experiencing corrosion at the 7-way trailer connection. This causes intermittent flashing/flickering of the trailer lights.
  dealers will install the missing grommet on all affected chassis. If a connector is found defective, it will be replaced with a new connector. Owner notification is began on march 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw1. Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 2007112 [Canada]: Powertrain
  On certain trucks, the wiring, parts, or transmission programming required for the auto neutral feature to function as designed were either not installed, connected, or programmed properly. If any of these conditions exists, the transmission will not automatically shift into neutral when left in drive with the parking brake engaged. The vehicle could move without warning increasing the risk of a crash. Correction: dealers will inspect and, if needed, make the necessary repairs.

  Show Content

• Recall 2005069 [Canada]: Heater and defroster
  On certain vehicles, burner tubes in the webasto dbw 2010 scholastic coolant heater may begin deteriorating at an accelerated rate and could fail. Burner tube failure could result in an increase in exhaust gas temperature which could ignite combustible material in or around the vehicle. Correction: dealers will replace the burner tubes.

  Show Content

• Recall 2004131 [Canada]: Electrical
  On certain vehicles, the cab transmission harness may have been incorrectly wired during production. As a result, the neutral start feature of the transmission might be disabled, allowing the vehicle to start in gear. Correction: dealer will inspect, and correct the connections in the wiring harness if the defect is found.

  Show Content

• Recall 2004260 [Canada]: Electrical
  On certain vehicles, a potential chaffing point may exist between a heat shield on the engine and the wiring for the alternator. The interference is only present with the combination of a caterpillar c11/c13 engine and the optional leece neville brushless alternator which is longer than any other alternators installed by kenworth. Correction: dealers will replace the alternator to a brush-type alternator that is shorter in length and provides the necessary clearance to all surrounding components.

  Show Content

• Recall 2003034 [Canada]: Lights and instruments
  On certain vehicles a rubber grommet from the trailer light line connector is missing. Kenworth chassis equipped with trailer connections are experiencing corrosion at the 7-way trailer connector with the light line because of the missing grommet, which causes intermittent flashing/flickering of the trailer lights. The elimination of this grommet allowed water to enter the connection and begin corroding, which can cause a short and/or possible fire hazard. Correction: dealer will install the missing grommet and if a connector is found defective, it will be replaced.

  Show Content

• Recall 2003121 [Canada]: Other
  On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: dealers will replace the bracket pins.

  Show Content

• Recall 2003163 [Canada]: Other
  On certain vehicles, the grabhandles were mounted too high and may limit the ability to maintain 3-points of contact at all times. This condition may cause a person to slip and/or fall and could lead to personal injury. Correction: dealer will relocate the handle to the proper height.

  Show Content

• Recall 2003183 [Canada]: Electrical
  On certain vehicles, the optional battery-mounted 50 amp and/or 60 amp circuit breaker had been wired incorrectly. If enough accessories are being used simultaneously during operation of these vehicles, this error in wiring can cause the cab power and engine to shut down prematurely without warning and could result in loss of vehicle control. Correction: dealer will correct the electrical wiring if defect is found.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

While driving at night the headlights shut off without warning. This forced the driver to pull off the road, because lack of visibility. Consumer contacted the dealership, and mechanic determined headlight wiring melted.*ak