Kenworth W900 2002

• Recall 56839 [USA]: Kenworth recall no. 03kw7.customers can also contact the national highway traffic safety administration's auto safety hotline
  On certain heavy duty trucks, the main cab wiring harness was incorrectly connected to the 50 amp circuit breaker instead of the 135 amp breaker.
  dealers will inspect the vehicles and the wiring will be corrected if necessary. Owner notification began september 16, 2003. Owners should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw7.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 35433 [USA]: This condition could cause a person to slip and/or fall and could lead to personal injury.
  On certain heavy duty trucks equipped with vertical tail pipes, the frame access grabhandle is mounted too high.
  dealers will inspect the grabhandle location and if determined to be mounted too high, the handle will be relocated to the proper height. Owner notification began july 29, 2003. Owners should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw5.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 34144 [USA]: If left undetected or corrected it could lead to the separation of the fifth wheel top plate from its mounting structure, possibly resulting in a crash.
  On certain trucks equipped with jost international jsk 37u series fifth wheels, a fatigue crack can develop in the bracket pin weld under certain loading conditions.
  dealers will replace the bracket pins and repair instructions free of charge. Peterbilt's owner notification began june 20, 2003. Kenworth's owner notification began june 12, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact peterbilt at 940-591-4201 or kenworth 425-828-5440.
  peterbilt recall no. 403-c/kenworth recall no. 03kw4.Also, customers can contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 54826 [USA]: This could cause an electrical short and/or possible fire hazard.
  Certain trucks equipped with trailer connections fail to comply with the requirements of federal motor vehicle safety standards (fmvss) no. 121, "air brake systems," and no. 108, "lamps, reflective devices, and associated equipment." the supplier removed a rubber grommet from the trailer light line connector. The vehicles are experiencing corrosion at the 7-way trailer connection. This causes intermittent flashing/flickering of the trailer lights.
  dealers will install the missing grommet on all affected chassis. If a connector is found defective, it will be replaced with a new connector. Owner notification is began on march 14, 2003. Owners who take their vehicles to an authorized dealer on an agreed upon service date and do not receive the free remedy within a reasonable time should contact kenworth at 1-425-828-5440.
  kenworth recall no. 03kw1. Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall 2003034 [Canada]: Lights and instruments
  On certain vehicles a rubber grommet from the trailer light line connector is missing. Kenworth chassis equipped with trailer connections are experiencing corrosion at the 7-way trailer connector with the light line because of the missing grommet, which causes intermittent flashing/flickering of the trailer lights. The elimination of this grommet allowed water to enter the connection and begin corroding, which can cause a short and/or possible fire hazard. Correction: dealer will install the missing grommet and if a connector is found defective, it will be replaced.

  Show Content

• Recall 2003121 [Canada]: Other
  On certain vehicles, fatigue cracks can initiate in the weld joining the bracket pin to its mounting flange on the fifth wheel assembly. Weld failures could lead to the loss of the pin and the potential separation of the fifth wheel top plate from its mounting structure without warning. Correction: dealers will replace the bracket pins.

  Show Content

• Recall 2003163 [Canada]: Other
  On certain vehicles, the grabhandles were mounted too high and may limit the ability to maintain 3-points of contact at all times. This condition may cause a person to slip and/or fall and could lead to personal injury. Correction: dealer will relocate the handle to the proper height.

  Show Content

• Recall 2003183 [Canada]: Electrical
  On certain vehicles, the optional battery-mounted 50 amp and/or 60 amp circuit breaker had been wired incorrectly. If enough accessories are being used simultaneously during operation of these vehicles, this error in wiring can cause the cab power and engine to shut down prematurely without warning and could result in loss of vehicle control. Correction: dealer will correct the electrical wiring if defect is found.

  Show Content

• Recall 2002019 [Canada]: Electrical
  On certain vehicles the power distribution box was manufactured with insufficient torque applied to the nut of the main power feed-through stud. Insufficient torque on the subject nut could lead to: 1) electrical arcing of wires inside of the pd box or, 2) an interrupted power supply to the vehicle's electrical system. Either of which could lead to a loss of vehicle electrical power and possibly vehicle control without warning. Correction: the vehicles will be inspected and the nut on the main power feed-through stud will be tightened to the proper specification.

  Show Content

• Recall 2002161 [Canada]: Brakes
  On certain vehicles, the delivery port inside bendix trailer hand control brake valves may be partially blocked due to a problem during the molding process. Such a blockage may slow the delivery and exhaust of air to and from the trailer brakes when they are operated by this hand control valve which may result in delayed trailer brake application and release. Correction: the dealer will inspect and replace defective valves.

  Show Content

• Recall 2001248 [Canada]: Engine
  Certain heavy duty trucks. The driveline u-joint fasteners at the output yoke of the transmission were improperly tightened. Under-tightened fasteners can lead to the driveline becoming detached from the vehicle resulting in property damage or personal injury. Correction: dealers will tighten the driveline fasteners to the proper specification.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

Consumer noticed at home. The front chassis was broke he could kill many people. Dealer has been notified. Please provide further information. Ts