Lincoln Mark 1986

• Recall 25994 [USA]: Coupling could disengage due to fuel pressure,vibration, and engine movements; this would cause loss of fuel which, inpresence of an ignition source, creates a fire risk.
  Spring lock fuel line coupling may not be properly engaged.
  install retainer clips over the couplings to prevent coupling separation and fuel leakage.
  system: fuel line couplingvehicle description: passenger cars and light trucks equipped with fuelinjection.

  Show Content

• Recall 27533 [USA]: System: ignition lock cylinder/brakes.vehicle description: passenger cars equipped with a brake system supply motor for hydrau
  The ignition lock cylinder may hang up and not fully return to the "on" position from the "start" position after starting the engine. If this occurs, the engine will remain running, but the battery current to the brake system supply motor will be interrupted. Consequence of defect: with power to most accessories and the brake system supply motor interrupted, the power assist to the front brake will be lost and after about 10 to 15 normal brake stops, loss of rear brake function will result, causing increased stopping distance. However, the instrument brake warning light will illuminate prior to reduced braking capability and if warning is not heeded, an accident may occur.
  replace ignition lock cylinders with revised design cylinders.
  system: ignition lock cylinder/brakes.Vehicle description: passenger cars equipped with a brake system supply motor for hydraulic rear brakes and power assist front brakes.

  Show Content

• Recall 1987098 [Canada]: Fuel supply
  On vehicles with efi or cfi, the spring-lock fuel line coupling used to connect the fuel supply and return lines to the efi fuel rails or to the cfi throttle bodies as well as other fuel line connections near the dash panels on some vehicles, could disengage during vehicle use. Should this occur, loss of fuel will result, providing the potential for a vehicle fire. Correction: coupling retainer clips will be installed on affected vehicles. Note: escort vehicles are equipped with efi and cfi. Lynx vehicles are equipped with cfi only. Efi - electronic fuel injection cfi - central fuel injection

  Show Content

• Recall 1986025 [Canada]: The wiring connections to the brake fluid level sensor on the master cylinder cap were reversed due to a design error, resulti
  The wiring connections to the brake fluid level sensor on the master cylinder cap were reversed due to a design error, resulting in failure of the sensor to transmit a signal to the brake when the fluid level is less than one-fourth full. This is in non-compliance with c.M.V.S.S. 105 - hydraulic brake systems.

  Show Content

• Recall 1986086 [Canada]: Brakes
  Vehicles are equipped with a brake supply motor that provides hydraulic pressure for the rear brakes and power assist to the front brakes.The ignition lock cylinder may not fully return to the "on" position after starting the engine. If this occurs, the battery current to the brake system supply motor will be interrupted. In this condition, the brake system will supply 10 to 15 normal brake stops prior to loss of rear brake function, resulting in increased stopping distances and possible vehicle crash. Correction: ignition lock cylinders will be replaced with revised design cylinders.

  Show Content

• Recall 1986087 [Canada]: Brakes
  Vehicles are equipped with a brake system supply motor that provides hydraulic pressure for the the rear brakes and power assist to the front brakes. There is a potential for welding of the contacts in the brake system relay. If this occurs, the brake pump motor will run continuously causing overheating and will eventually stop operating. After 10 to 15 normal brake stops, loss of brake function will occur, resulting in increased stopping distances and risk of vehicle crash. Correction: pump motor relays will be replaced.

  Show Content

• Recall 1985107 [Canada]: The fuel injection throttle bodies may have a casting flash on the face of the throttle body bores. if this condition exists,
  The fuel injection throttle bodies may have a casting flash on the face of the throttle body bores. If this condition exists, a piece of flash may break loose and might become lodged between the throttle plate and bore, preventing the throttle from returning to the idle position. .

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Brake failure investigation # PE86067

  Analysis:the 8 complaints in odi complaint file revealed sudden brakefailure.Ford has issued a service bulletin, 03250000, on 1985 mark viisfor an out of position wiring harness.In this case the braking sensormay short causing power brake failure.There have been no recallspertaining to this alleged defect.Further investigation is suggested toevaluate this alleged defect.Status:ir prepared.Proposed action:to open a preliminary evaluation.
  

  Show Content

Noticed the brake light came on minutes later while on my way home. I come to a stop at a light and the brakes had completely failed. I was not aware of any recall until i was informed by my mechanic that there was a recall on the abs pump motor. The car was purchased around 1991-1992 it was a private sale. *tr

Consumer does not have original rcall letter 87v139000 from dealer concerning fuel line leak. *ak

Vehicle has stalled numerous times at any speed. Repair shop cannot remedy problem. *ak

A short in the ignition switch caused fire.

Electrical short or shock caused the wires in the ignition to burn out. Please describe. *ak

Vehicle parked in garage while owner was asleep. Husband died of smoke inhalation.

Drivers motor belt jammed in locked position. *dsh

In trying to pull out of snow, the rear right tire caught fire damaging the vehicle completely. Yh

Air conditioner shut off/ dash buttons stopped working, and brakes failed while driving. *ak