Mercedes-benz-cars-uk-l-t-d Slk 2015
Complaint Information: OBD II Codes
Recall R/2017/124 [UK]: Faulty control unit may cause vehicle to perform outside specification
Where a control unit coding was updated in a workshop between 3 december 2016 and 5 december 2016 the coding may not correspond to the specification and may trigger unplanned action in the vehicle. The safety and emissions systems may not react as design intent.
recall the vehicles that are likely to be affected and update the software in the corresponding control units.Recall R/2016/093 [UK]: Electrical fault could allow vehicle to roll away when left parked
On certain vehicles fitted with 9 speed transmission the back up battery may not connect during main battery failure. This may prevent selection of park on the transmission or operation of the electronic parking brake.
on affected vehicles adapt harness to manufacturer's specification and recode the system.Recall R/2017/157 [UK]: Brakes may overheat creating a risk of smoke and/or fire
The software for the electronic stability program (esp) is faulty. The fault could lead to a low residual pressure in the hydraulic system so the brakes are applied and gain heat. This increased heat will apply the brakes further and could adversely affect the brake fluid. Fire in the wheel housing cannot be ruled out.
recall the vehicles that are likely to be affected and update the software for the esp.Recall R/2015/208 [UK]: Engine may fail
The camshaft could break and damage the engine due to it not being manufactured to the correct specification. If the condition occurs it will lead to a sudden loss of drive thereby increasing the risk of a collision.
recall the vehicles that are likely to be affected and replace the intake camshaft.Recall R/2015/259 [UK]: Risk of fire
The high pressure fuel lines have not been manufactured to the correct specification which over time can lead to crack formation and fuel leaking. Fuel escaping in the presence of an ignition source could lead to fire.
recall the vehicles that are likely to be affected and replace the high pressure fuel lines.Recall R/2020/243 [UK]: Engine control unit software to be updated
Improve the vehicle emissions via software updates.
update the relevant control unit?S software and if necessary replace the nox sensors.Recall R/2020/011 [UK]: Emission output requires improvement
Emission output requires improvement
update software in the engine control unit and replace the nox sensor if required.
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.