Mercedes-benz Cls-class 2013

• Recall R/2017/124 [UK]: Faulty control unit may cause vehicle to perform outside specification
  Where a control unit coding was updated in a workshop between 3 december 2016 and 5 december 2016 the coding may not correspond to the specification and may trigger unplanned action in the vehicle. The safety and emissions systems may not react as design intent.
  recall the vehicles that are likely to be affected and update the software in the corresponding control units.

  Show Content

• Recall R/2015/041 [UK]: Fire may occur
  A seal between bonnet and engine compartment may when the bonnet is opened temporarily stick to the bonnet. If this happens the seal may detach form its fixing and can fall into the gap between engine and partition wall. It is then possible the seal can make contact with the exhaust and under certain conditions catch fire.
  on affected vehicles install additional clips to retain the seal.

  Show Content

• Recall R/2020/243 [UK]: Engine control unit software to be updated
  Improve the vehicle emissions via software updates.
  update the relevant control unit?S software and if necessary replace the nox sensors.

  Show Content

• Recall R/2019/256 [UK]: To achieve an improvement in the emissions via software updates
  Improve the vehicle emissions via software updates.
  update the diesel engine control unit software and add a supplementary booklet for the operator's manual

  Show Content

• Recall 2018724 [Canada]: Steering
  On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (quebec, new brunswick, nova scotia, prince edward island, and newfoundland & labrador), the bolts that attach the electric power steering assist motor to the steering gear housing may corrode and break. This could cause a loss of power steering assist. The resulting increase in steering effort could create the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the mounting bolts and apply a corrosion protection coating to the gear housing and bolts. If the bolts bolt cannot be removed, a replacement steering gear will be installed.

  Show Content

• Recall 2015099 [Canada]: Lights and instruments
  Certain vehicles may not comply with the requirements of canada motor vehicle safety standard 108 - lighting system and retro reflective devices. Rear side markers may not have been programmed properly and may fail to meet the photometric performance requirements of the standard. This could reduce vehicle conspicuity, which could increase the risk of a crash causing injury and/or damage to property. Correction: dealers will reprogram the signal acquisition module.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.