Mercedes-benz Cls-class 2015

• Recall R/2017/124 [UK]: Faulty control unit may cause vehicle to perform outside specification
  Where a control unit coding was updated in a workshop between 3 december 2016 and 5 december 2016 the coding may not correspond to the specification and may trigger unplanned action in the vehicle. The safety and emissions systems may not react as design intent.
  recall the vehicles that are likely to be affected and update the software in the corresponding control units.

  Show Content

• Recall R/2015/171 [UK]: Fire may occur
  The engine compartment seal may not be fully secure. There is a possibility that the seal may become dislodged and fall between the engine and the fire wall. If this occurs it is possible for the seal to contact very hot items such as the catalytic converter and a fire to start.
  recall the vehicles that are likely to be affected and fit a new seal with fittings.

  Show Content

• Recall R/2015/259 [UK]: Risk of fire
  The high pressure fuel lines have not been manufactured to the correct specification which over time can lead to crack formation and fuel leaking. Fuel escaping in the presence of an ignition source could lead to fire.
  recall the vehicles that are likely to be affected and replace the high pressure fuel lines.

  Show Content

• Recall R/2020/243 [UK]: Engine control unit software to be updated
  Improve the vehicle emissions via software updates.
  update the relevant control unit?S software and if necessary replace the nox sensors.

  Show Content

• Recall R/2019/256 [UK]: To achieve an improvement in the emissions via software updates
  Improve the vehicle emissions via software updates.
  update the diesel engine control unit software and add a supplementary booklet for the operator's manual

  Show Content

• Recall 2018724 [Canada]: Steering
  On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (quebec, new brunswick, nova scotia, prince edward island, and newfoundland & labrador), the bolts that attach the electric power steering assist motor to the steering gear housing may corrode and break. This could cause a loss of power steering assist. The resulting increase in steering effort could create the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the mounting bolts and apply a corrosion protection coating to the gear housing and bolts. If the bolts bolt cannot be removed, a replacement steering gear will be installed.

  Show Content

• Recall 2015359 [Canada]: Engine
  On certain vehicles, the rubber seal at the top edge of the secondary bulkhead of the engine compartment may have been damaged during manufacturing. Should a sufficient length of rubber seal be displaced from the bulkhead, and the seal were to drop down, it could result in the loose end of the seal contacting exhaust components. This could increase the risk of fire resulting in injury and/or damage to property. Correction: dealers will replace the rubber seal in the engine compartment.

  Show Content

• Recall 2015099 [Canada]: Lights and instruments
  Certain vehicles may not comply with the requirements of canada motor vehicle safety standard 108 - lighting system and retro reflective devices. Rear side markers may not have been programmed properly and may fail to meet the photometric performance requirements of the standard. This could reduce vehicle conspicuity, which could increase the risk of a crash causing injury and/or damage to property. Correction: dealers will reprogram the signal acquisition module.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.