Mercedes Benz E Class 2005

• Recall 77341 [USA]: In the event of a vehicle crash, the electrical fuel pump may not receive a crash signal that is required for the fuel pump to disconnect and prevent future fuel delivery as designed.
  Mercedes-benz is recalling my 2006-2008 m-class, r-class, my 2005-2009 slk-class, my 2005-2008 c-class, my 2003-2004 and 2006-2008 clk-class, my 2003-2008 e-class, my 2004 and 2008 cl-class, my 2008 cls-class, my 2004 and 2007-2008 s-class, my 2003 g-class, and my 2003-2004, 2006 and 2009 sl-class vehicles. A software calibration number (scn) coding received on the affected vehicles during a recent workshop visit was incorrect. Depending on the model year and model affected, the results of an incorrect scn coding can affect a number of vehicle safety and emission functions including the following types of functions: (1) the fuel gauge readings may be incorrect; (2) a stuck fuel-level sensor may not be displayed in the instrument cluster; (3) the obd system may cause the check engine light to illuminate incorrectly; and, (4) the speedometer may be out of tolerance.
  dealers will recode the scn free of charge. The recall began on august 30, 2008. Owners may contact mercedes-benz at 1-800-367-6372.
  mercedes-benz recall no. 2008 070001.Customers may contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty: 1-800-424-9153); or go to http://www.Safercar.Gov.

  Show Content

• Recall 36332 [USA]: In the hydraulic back-up mode, the driver has braking power sufficient to stop the vehicle, although greater brake pedal pressure is required and the brake pedal travel will be noticeably longer.
  On certain vehicles, the sensotronic brake control (sbc) system may prematurely shift to the hydraulic back-up function mode, due to deterioration of the wiring harness connection, or due to premature failure of the hydraulic pump.
  dealers will install a bracket and replacement ground wire to the sbc pump unit on all vehicles free of charge. Additionally dealers will inspect and replace the sbc pump unit in sl vehicles produced during a limited production period. The recall began on august 8, 2005. Owners may contact mercedes-benz at 1-800-367-6372.
  mercedes-benz recall no. 2005070007 and 2005110001. Customers may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to http://www.Safercar.Gov.

  Show Content

• Recall 55619 [USA]: If vehicles are not routinely serviced and have extremely high mileage combined with a high number of brake actuations, or a high brake actuation frequency, the pump motor of the sbc may run out of permissible tolerances, thereby triggering the hydraulic function mode.
  On certain vehicles, the electronic monitoring system of the sensotronic brake control (sbc) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacceptable pressure gradient is detected, the system will switch, as it is designed to do, into the hydraulic function mode.
  dealers will inspect the sbc hydraulic unit, replacing it if necessary. The recall began on october 21m 2004. Owners should contact mercedes-benz at 1-800-367-6372.
  mercedes-benz recall no. 2004 050014.Customers can also contact the national highway traffic safety administration's auto safety hotline at 1-888-dash-2-dot (1-888-327-4236).

  Show Content

• Recall R/2005/056 [UK]: Brake pedal may require more effort than expected
  In isolated cases it is possible for vibrations within the vehicle to in turn vibrate the wiring harness connected to the sensotronic brake control unit. This causes the internal contacts within the unit to suffer abrasion and subsequent resistance increase. The resultant affect is that more effort will be required on the brake pedal to stop the vehicle.
  recall the vehicles that are likely to be affected and mount an additional bracket to the electrical harness to prevent relative movement.

  Show Content

• Recall R/2008/147 [UK]: Engine emergency shut off on board diagnosis or tank/speedo signal may be affected
  Possibility of transfer of incorrect control unit software which could affect engine shut off control in an emergency situation or the on board diagnosis system or tank/speedometer signal
  recall affected vehicles and replace sam control unit

  Show Content

• Recall R/2017/124 [UK]: Faulty control unit may cause vehicle to perform outside specification
  Where a control unit coding was updated in a workshop between 3 december 2016 and 5 december 2016 the coding may not correspond to the specification and may trigger unplanned action in the vehicle. The safety and emissions systems may not react as design intent.
  recall the vehicles that are likely to be affected and update the software in the corresponding control units.

  Show Content

• Recall R/2019/458 [UK]: The bonding between the glass panel and the sliding roof frame may not meet specifications
  The bonding between the glass panel and the sliding roof frame might not meet specifications
  check the glass panel bonding on the affected vehicles and replace the sliding roof if necessary

  Show Content

• Recall R/2021/277 [UK]: The driver's air bag may have a chemical change to its propellant over time
  The driver's airbag may have a chemical change to its propellant over time.
  replace the driver?S airbag.

  Show Content

• Recall R/2021/358 [UK]: Takata airbag might not deploy as specified
  Certain climatic conditions may cause a chemical change to the airbag propellants?Over time.?
  replace the driver and?Passenger airbags.?

  Show Content

• Recall R/2021/145 [UK]: The bonding between the glass panel and the sliding roof frame might not meet specifications
  The bonding between the glass panel and the sliding roof frame might not meet specifications.
  check the glass panel bonding on the affected vehicles and replace the sliding roof if necessary.

  Show Content

• Recall 2021478 [Canada]: Structure
  Issue: this recall is for certain vehicles inspected under mercedes-benz recall 7891003 (transport canada recall 2019-668) that require a second inspection. On certain vehicles, the sunroof glass may not be properly attached to the sliding roof frame. Over time, the glass can become loose and could separate from the vehicle. Note: this recall affects 2006 and 2007 models originally equipped with a sunroof. Additionally, some 2001-2011 models may have had an affected sunroof installed during a repair. Safety risk: a sunroof that detaches from the vehicle could create a road hazard for others and increase the risk of a crash. Corrective actions: mercedes-benz will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the bonding of the sunroof glass. Dealers will replace the sliding roof, if necessary.

  Show Content

• Recall 2019668 [Canada]: Structure
  Issue: on certain vehicles, the sunroof glass may not be properly attached to the sliding roof frame. Over time, the glass can become loose and could separate from the vehicle. Note: this recall affects 2006 and 2007 models originally equipped with a sunroof. Additionally, some 2001-2011 models may have had an affected sunroof installed during a repair. Safety risk: a sunroof that detaches from the vehicle could create a road hazard for others and increase the risk of a crash. Corrective actions: mercedes-benz will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the bonding of the sunroof glass. Dealers will replace the sliding roof, if necessary.

  Show Content

• Recall 2008242 [Canada]: Other
  Certain vehicles may have been programmed with incorrect software calibration data during the manufacturing process. This could affect various functions such as: the electric fuel pump may not receive a signal which, in case of a crash, may prevent the fuel pump from disconnecting as designed; the maximum speed limiter may not be activated; the fuel gauge readings may be incorrect; a stuck fuel-level sensor may not be displayed in the instrument cluster; the speedometer may be out of tolerance which, as a result, may indicate inaccurate vehicle speed; the on-board diagnostic (obd) system may reduce the emission level applicable to the vehicle, causing the check engine light to illuminate incorrectly. Correction: dealers will reprogram the electronic control module.

  Show Content

• Recall 2005094 [Canada]: Brakes
  On certain vehicles, the sensotronic brake control (sbc) unit may contain a pump piston which is out of permissible tolerances. Also, vibrations within the electrical connector may cause a loss of electrical continuity. Both conditions may result in the system reverting to hydraulic function mode. A loss of brake power assist would result in increased pedal effort and extended stopping distance. Correction: dealers will inspect and, if required, replace the sbc pump unit.

  Show Content

• Recall 2004210 [Canada]: Brakes
  The electronic monitoring system of the sensotronic brake control (sbc) is designed to monitor the pressure gradient within the high pressure line of the brake system. If an unacceptable pressure gradient is detected, the system will switch, as it is designed to do, into the hydraulic function mode. Daimlerchrysler ag has determined that in certain instances, if vehicles are not routinely serviced and have extremely high mileage combined with a high number of brake actuations or a high brake actuation frequency, the pump motor of the sbc may run out of permissible tolerances, thereby triggering the hydraulic function mode. Correction: dealers will re-program the sbc hydraulic unit. A software update will provide a clear maintenance notice on the vehicle display and assure continuous pump speed operation within tolerances.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

• Driver air bag circuit high resistance investigation # PE10017

  Mercedes-benz usa (mbusa) has reported a high number of warranty claims for air bag warning lamp illumination due to a diagnostic fault code 9103 or 9123 indicating a high resistance in the drivers frontal air bag firing circuit.Mbusas testing and evaluation have shown that this condition is the result of a faulty connector (specifically, improper wire crimp) but that it will not prevent proper deployment of the drivers frontal air bag.The faulty connector can cause the air bag circuit resistance levels to exceed the threshold that illuminates the air bag warning lamp, but they do not exceed a higher limit at which proper deployment of the air bag may no longer occur.The agency believes that further expenditure of agency resources does not appear to be warranted at this time.The closing of this investigation does not constitute a finding by nhtsa that no safety-related defect exists.The agency will monitor the issue and reserves the right to take future action if warranted by the circumstances.During the investigation, odi learned that mbusa will initiate a warranty extension program to address the faulty connectors in subject model year 2005 and 2006 e-class and other mbusa model/model year vehicles.This action will extend the warranty coverage for this issue to 10 years or 100,000 miles, whichever occurs first.Mbusa will notify all affected vehicle owners of this action.A bulletin describing this program is available in the investigative file.
  

  Show Content

Filled fuel tank , came home ,parked in garage and noticed a strong fuel smell. Fuel was leaking on floor and i have to leave it outside now. *tr

I recently bought a used 2005 mercedes e320 with 126.3k miles. At time of transaction, car had half a tank of fuel only. Couple days later, when i went to refuel, i filled up tank all the way to top, i drove home and as soon as i exited car, i could smell a very strong odor of gasoline inside car and inside left rear wheel well. I inspected the car and after lifting rear seat cushion, i opened the covers to gas tank to find there was a fuel leak at the fuel sending unit, driver's side, about 1-2 ounces of fuel. Today i purchased an updated new fuel sending unit from mb dealer and will need to get it installed. When tank is three quarter full or less, you don't smell the odor and no sign of leak is present. This appears to be a common problem among mercedes e-class. I've learned this thru my most recent online search. I'm so disappointed in mercedes benz for this poor manufacturing. *tr

After filling up the fuel tank with gasoline, i smell an odor of gas until the tank is down to about 3/4 full. *tr

The car has a strong odor of gasoline both inside and outside of their vehicle, particularly after refueling. It appears that the gasket on the fuel tank leaks. *tr

Srs system malfunction. *tr

I filled my gas tank and the next day i smelled gas both near my drivers side wheel well and inside the car in the rear seat area. I filled the car as i always did until click and i am sure none spilled, as i am very fussy about my car. I cannot put the car in the garage as it fills the garage with fumes. This has happened twice now upon fueling up. It never happened before. I have seen where others i know have the same type of problem with the same model mercedes. *tr

We first noticed a strong fuel smell when the vehicle was filled up, but shortly after we will the vehicle fuel started to drip onto the pavement near the drivers side rear wheel area. *tr

Fuel tank was leaking under the back seat when fill up tank. *tr

While driving at approximately 50 mph, the sbs system warning light came on along with loss of most braking ability. I managed to stop the car, turn around and return about 8 miles to my home in "limp home" mode. There was no warning whatsoever. I then call the mb dealership which sent a truck to pick up the car. The sbs hydraulic unit had failed and was replaced under extended warranty at no cost. While i am not complaining about the cost (none), the failure could have caused an accident with the loss of brake ability. I take road trips to the colorado mountains and if this had happened there, i could have suffered a fatal injury. This system is defectively engineered and should be replaced on all mercedes cars so equipped. *tr