Mercedes-benz S-class 2017

• Recall R/2017/124 [UK]: Faulty control unit may cause vehicle to perform outside specification
  Where a control unit coding was updated in a workshop between 3 december 2016 and 5 december 2016 the coding may not correspond to the specification and may trigger unplanned action in the vehicle. The safety and emissions systems may not react as design intent.
  recall the vehicles that are likely to be affected and update the software in the corresponding control units.

  Show Content

• Recall R/2017/147 [UK]: Left front seat belt pre-tensioner may not meet specification
  The propellant mix in certain seatbelt pre-tensioners ignitors may be incorrect. If the front seatbelt pre-tensioners are deployed the lock function of the pre-tensioners cannot be guaranteed.
  recall the vehicles that are likely to be affected and replace the front seatbelts that are likely to be affected.

  Show Content

• Recall R/2017/214 [UK]: Oil leak from turbocharger feed pipe.
  Under certain conditions the oil feed pipe to the turbocharger may leak.Oil may contact hot components and there is a risk of fire.
  on affected vehicles replace the oil feed line to the turbocharger.

  Show Content

• Recall R/2017/233 [UK]: Some occupant safety systems may malfunction in the event of a collision
  Due to incorrect wiring assembly the vehicles main power supply is disconnected after airbag deployment. This will affect the operation of vehicle safety functions such as automatically unlocking doors. The srs systems are still functional.
  on affected vehicles carry out manufacturer's recommended modification.

  Show Content

• Recall R/2020/243 [UK]: Engine control unit software to be updated
  Improve the vehicle emissions via software updates.
  update the relevant control unit?S software and if necessary replace the nox sensors.

  Show Content

• Recall R/2019/256 [UK]: To achieve an improvement in the emissions via software updates
  Improve the vehicle emissions via software updates.
  update the diesel engine control unit software and add a supplementary booklet for the operator's manual

  Show Content

• Recall R/2018/266 [UK]: To improve emissions of the affected vehicles.certain calibrations of functionalities must be changed in the engine management
  Improve the vehicle emissions via software updates.
  update the diesel engine control unit software and add a supplementary booklet for the operator's manual

  Show Content

• Recall R/2021/274 [UK]: Vehicles with a panoramic sunroof the polycarbonate panel may not have been bonded correctly during a prior service repair
  The polycarbonate panel located between the windshield and the panoramic sunroof may not have been bonded correctly during a prior service repair.
  remove the bonded panel and install a new polycarbonate panel if required.

  Show Content

• Recall R/2017/253 [UK]: Right front seat belt pre-tensioner may not meet specification
  The right front seat belt pretensioner may not conform to specification . This may adversely affect it's operation in the event of an accident.
  replace the pretensioner on affected vehicles.

  Show Content

• Recall R/2018/010 [UK]: Front seat belt tensioners may not function
  The front seatbelt pre-tensioner ignitors may not perform as expected. This could increase the risk of injury to the seat occupants. The lock function of the seatbelts is not impaired.
  on affected vehicles replace seatbelts with quality assured units.

  Show Content

• Recall R/2019/108 [UK]: A reset in the cpc control unit could occur whilst driving
  The eco start-stop function may be disabled and cause the vehicle to stall.
  the affected vehicles are to be recalled and the software updated.

  Show Content

• Recall R/2020/240 [UK]: The seat belt warning function does not meet the specification
  The seat belt warning function does not meet the specification
  activate the correct seat belt warning scenario in the instrument cluster

  Show Content

• Recall R/2021/082 [UK]: The communication module may be deactivated
  The communication module may be deactivated
  carry out a check of the configuration of the communication module on affected vehicles and if necessary activate the communication module.

  Show Content

• Recall R/2021/106 [UK]: The behaviour of the emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall R/2021/133 [UK]: The emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall R/2021/134 [UK]: The behaviour of the emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall R/2018/221 [UK]: Two nuts attaching the busbars within the prefuse box in the trunk may not have been installed
  Two nuts attatching the busbars within the prefuse box may not have been installed
  check the prefuse box and replace if necessary on affected vehicles

  Show Content

• Recall R/2018/249 [UK]: Certain parameters of the active lane keeping assist within the multipurpose camera software may not meet specification
  Active lane keeping assist might not initiate a brake intervention in case of an unwanted lane change.
  update the multipurpose camera software of affected vehicles.

  Show Content

• Recall R/2019/098 [UK]: Hands off detection function might not meet specifications
  The hands-off-detection function (hod) might not meet specifications.
  the position of the steering boot will be checked and corrected if necessary.

  Show Content

• Recall R/2020/188 [UK]: The material of two closure plugs on the engine may not withstand the maximum loads whilst driving
  The material of two closure plugs on the engine might not withstand the maximum loads while driving.
  rework the closure plugs on the engine on the affected vehicles

  Show Content

• Recall R/2020/236 [UK]: The emergency call system (ecall) does not meet the specification
  On affected vehicles the software of the communication module for the emergency call system does not meet the specification
  update the software of the communication module for the emergency call system

  Show Content

• Recall R/2019/269 [UK]: The software of the radar control unit may not meet specification
  ; the software of the radar control unit might not meet the specification
  update the software of the radar sensor control unit on the affected vehicles.

  Show Content

• Recall R/2021/111 [UK]: The behaviour of the emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall R/2021/133 [UK]: The emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall R/2021/134 [UK]: The behaviour of the emergency call system might not meet specifications
  The behaviour of the emergency call system might not meet specifications.
  update the software of the communication module for the emergency call system.

  Show Content

• Recall 2018724 [Canada]: Steering
  On certain vehicles originally sold or currently registered in areas of heavy road salt usage during winter months (quebec, new brunswick, nova scotia, prince edward island, and newfoundland & labrador), the bolts that attach the electric power steering assist motor to the steering gear housing may corrode and break. This could cause a loss of power steering assist. The resulting increase in steering effort could create the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the mounting bolts and apply a corrosion protection coating to the gear housing and bolts. If the bolts bolt cannot be removed, a replacement steering gear will be installed.

  Show Content

• Recall 2017642 [Canada]: Structure
  Certain vehicles may fail to conform to canada motor vehicle safety standard (cmvss) 206 – door lock and door retention components. The left (driver's side) door locks may indicate a locked position, even when the door is not locked, which is contrary to the requirements of the standard. Correction: dealers will inspect the left door locks, and replace them as necessary.

  Show Content

• Recall 2017555 [Canada]: Steering
  On certain vehicles, a bracket for a transistor in the power steering control unit may break due to vibrations and temperature variations during vehicle operation. If the bracket were to break, the control unit may disable the power steering assist, which could unexpectedly increase steering effort, and increase the risk of a crash causing injury and/or damage to property. Correction: dealers will inspect the steering rack and replace it, if necessary.

  Show Content

• Recall 2017205 [Canada]: Seats and restraints
  Certain vehicles may have been equipped with front seat belt pretensioner igniters that do not meet specifications. This could cause the affected pretentioners to fail to deploy properly in the event of a crash (where deployment is warranted), which could increase the risk of injury to vehicle occupants. Correction: dealers will replace the affected front seat belt pretentioners.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.