Mitsubishi Asx 2010

• Recall R/2014/129 [UK]: Brake pedal fails to release
  Due to incorrect installation of the switch sleeve in the brake booster the switch sleeve may be cracked. As a result the tip of the switch sleeve could break off causing the brake pedal not to release with the effect of the vehicle being unable to restart/move/pull away.
  recall the vehicles that are likely to be affected to check the production date of the brake booster. Replace the brake booster if it is of the affected production dates.

• Recall R/2018/347 [UK]: Inappropriate ecu program for the battery deterioration judgment (state of charge)
  Inappropriate ecu program for battery deterioration judgement.
  reprogram the software with the countermeasure software.

• Recall R/2014/013 [UK]: Engine may stall
  Soot may build on the piston ring causing the ring to seize in the groove allowing combustion gases to by-pass the piston. If not rectified this if ignored could cause the piston to overheat and melt.
  recall the vehicles that are likely to be affected to reprogram the engine ecu with new version software to change the pilot injection timing.

• Recall R/2017/317 [UK]: Water ingress may damage the wiper motor
  Due to inappropriate water proof structure of the front deck water can ingress into the wiper motor. Water accumulated around the air breather hole might enter into the wiper motor when the motor is cooling down after operation. As a result the internal part of the front wiper motor may rust and seize in the worst case the wiper motor may not operate.
  the waterproof fabric has been introduced to the air breather cap since 10/01/2014 for rhd wiper motors. Check which type of breather cap is fitted and replace with new motor if the latest waterproof type is not fitted.

• Recall R/2017/318 [UK]: Tailgate gas spring end cap may corrode and come off
  Anti-corrosion treatment of the gas spring end cap in production was insufficient. The tailgate gas spring end cap corrodes to such an extent that the gas pressure inside can force the end cap to come off. In the worst case the end cap can hit the customer and/or the tailgate can fall down suddenly and result in possible injury.
  the anti-corrosion coating has been improved in vehicle production. On affected vehicles the rear tailgate gas springs will be replaced with improved gas springs.

• Recall R/2018/247 [UK]: Where tail pipe is welded to the exhaust silencer a crack may appear
  Exhaust tailpipe section may crack at silencer weld.
  check and replace silencer if cracked. Fit support bracket if not cracked.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.