Use the box here to look up VINs from MITSUBISHI as well as other manufacturers
NHTSA Mandated Recalls
Recall R/2014/013 [UK]: Engine may stall
Soot may build on the piston ring causing the ring to seize in the groove allowing combustion gases to by-pass the piston. If not rectified this if ignored could cause the piston to overheat and melt. recall the vehicles that are likely to be affected to reprogram the engine ecu with new version software to change the pilot injection timing.
Recall R/2017/317 [UK]: Water ingress may damage the wiper motor
Due to inappropriate water proof structure of the front deck water can ingress into the wiper motor. Water accumulated around the air breather hole might enter into the wiper motor when the motor is cooling down after operation. As a result the internal part of the front wiper motor may rust and seize in the worst case the wiper motor may not operate. the waterproof fabric has been introduced to the air breather cap since 10/01/2014 for rhd wiper motors. Check which type of breather cap is fitted and replace with new motor if the latest waterproof type is not fitted.
Recall R/2017/318 [UK]: Tailgate gas spring end cap may corrode and come off
Anti-corrosion treatment of the gas spring end cap in production was insufficient. The tailgate gas spring end cap corrodes to such an extent that the gas pressure inside can force the end cap to come off. In the worst case the end cap can hit the customer and/or the tailgate can fall down suddenly and result in possible injury. the anti-corrosion coating has been improved in vehicle production. On affected vehicles the rear tailgate gas springs will be replaced with improved gas springs.
Recall R/2018/247 [UK]: Where tail pipe is welded to the exhaust silencer a crack may appear
Exhaust tailpipe section may crack at silencer weld. check and replace silencer if cracked. Fit support bracket if not cracked.
Recall R/2018/180 [UK]: Parking brake caliper shaft boots incorrectly sealed
Due to improper sealing of parking brake caliper shaft boots water might penetrate inside and rust the shaft. As the result of continuous use the rust will erode into the internal caliper and the shaft becomes stuck causing decreased parking brake force. Due to improper manufacturing process automatic adjuster for brake pad clearance of rear brake caliper might not work properly. As the result as brake pad wear the clearance is not correctly adjusted and brake force becomes insufficient to hold a vehicle. In the worst case scenario parking brake will not work even though a lever is fully operated and parked vehicle may move. anti-rust coating (fluorine) has been applied to parking brake shaft from 27/01/2016 supplied parts & the inspection process for the caliper has been changed from 14/12/2014 supplied parts.
Recall R/2018/182 [UK]: Inappropriate water proof structure of the front deck
Due to inappropriate water proof structure of the front deck water can drop on the wiper link. The wiper link ball joint may corrode and cause excessive wear of the resin part of the ball joint. In the worst case the wiper link may detach itself and the windshield wipers may be inoperative. the water proof pad has been added to the end of wiper link rubber boot since april 1st 2016
Recall R/2018/180 [UK]: Parking brake caliper shaft boots incorrectly sealed
Due to improper sealing of parking brake caliper shaft boots water might penetrate inside and rust the shaft. As the result of continuous use the rust will erode into the internal caliper and the shaft becomes stuck causing decreased parking brake force. Due to improper manufacturing process automatic adjuster for brake pad clearance of rear brake caliper might not work properly. As the result as brake pad wear the clearance is not correctly adjusted and brake force becomes insufficient to hold a vehicle. In the worst case scenario parking brake will not work even though a lever is fully operated and parked vehicle may move. anti-rust coating (fluorine) has been applied to parking brake shaft from 27/01/2016 supplied parts & the inspection process for the caliper has been changed from 14/12/2014 supplied parts.
Recall R/2018/182 [UK]: Inappropriate water proof structure of the front deck
Due to inappropriate water proof structure of the front deck water can drop on the wiper link. The wiper link ball joint may corrode and cause excessive wear of the resin part of the ball joint. In the worst case the wiper link may detach itself and the windshield wipers may be inoperative. the water proof pad has been added to the end of wiper link rubber boot since april 1st 2016
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Vehicle Documentation
[pdf]User ManualOwner's ManualInstallation GuideSpecificationsWarranty Table of contents This owner s manual has been written in compliance with such laws and reg ulations but some the may become contradictory later amend ment Owners Manual ASX 2012 EUR mmc manuals ru asx user ASX - ENGLISH - OGWE12E1 ASX - ENGLISH - OGWE12E1 OWNER S MANUAL ASX Foreword Thank you for selecting an ASX as your new vehicle. E09200103936 This owner s manual will add to your understanding and full enjoyment of the many fine features of this vehicle. It contains information prepared t... lang:en score:54 filesize: 18.2 M page_count: 378 document date: 0000-00-00