Mitsubishi Rvr 2015

• Recall 2020216 [Canada]: Structure
  Issue: on certain vehicles, road salt can corrode the front cross-member (subframe). As a result, a lower control arm could eventually detach from the cross-member. This could cause a loss of vehicle control. Safety risk: a loss of control can create the risk of a crash. Corrective actions: mitsubishi will notify owners by mail and instruct you to take your vehicle to a dealer to inspect the front cross-member (subframe). If no significant corrosion is found, the dealer will spray a sealing and anti-corrosion coating both inside and on the cross-member. If significant corrosion is found, the dealer will replace the cross-member.

  Show Content

• Recall 2018083 [Canada]: Visual system
  On certain vehicles, water may drain from the windshield cowl area onto the front wiper link ball joint. Over time, this could result in corrosion and/or wear to the joint, which could result in the separation of the wiper link ball. If separation were to occur, the windshield wipers could become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the wiper link rod with a countermeasure one, and will inspect the wiper motor crank arm and replace as necessary.

  Show Content

• Recall 2018053 [Canada]: Brakes
  On certain vehicles, insufficient rust prevention to the parking brake shaft and insufficient sealing performance of the rear brake caliper boot could allow water to penetrate inside these components causing corrosion. As a result, the parking brake shaft may become stuck causing brake dragging and/or decreased parking brake performance. Additionally, the automatic adjuster for the brake pad clearance of the rear brake caliper with the built-in parking brake may not work correctly. These conditions could lead to a vehicle rollaway, which would increase the risk of a crash causing injury and/or damage to property. Correction: dealers will inspect and repair the rear brakes as necessary.

  Show Content

• Recall 2017475 [Canada]: Engine
  On certain vehicles, defective electrical relays may have been installed in the power distribution center. This could cause various electrical circuits to fail, potentially resulting in engine stalling, reduced engine power, or loss of engine cooling fan function potentially resulting in engine overheating. These issues could increase the risk of a crash causing injury and/or damage to property. Correction: dealers will replace affected relay(s) with updated parts.

  Show Content

• Recall 2016530 [Canada]: Visual system
  On certain vehicles, water may drain from the windshield cowl area and potentially collect in the area of the wiper motor breathing hole. If the wiper motor is not operating, water could potentially enter the wiper motor through the breathing hole. If this occurs, over time, it could result in corrosion and/or an electrical conduction failure, both of which could result in the wiper motor not operating. If the wiper motor were to stop operating, the windshield wipers would become inoperative, which could limit the driver’s visibility under certain operating conditions which may increase the risk of a crash causing injury and/or damage to property. Correction: dealers will replace the wiper motor with an upgraded wiper motor that will prevent water intrusion.

  Show Content

• Recall 2016371 [Canada]: Other
  On certain vehicles equipped with a continuously variable transmission (cvt), the clamp(s) on the transmission fluid hoses may not have been properly closed during the assembly process. If operated under this condition, this could cause a hose to disconnect from the transmission fitting, leading to a transmission fluid leak. A transmission fluid leak could result in a loss of motive power which may increase the risk of a crash causing injury and/or damage to property. Correction: dealers will inspect and close any open transmission fluid hose clamps.

  Show Content

• Recall 2015410 [Canada]: Label
  Certain vehicles fail to comply with the requirements of canada motor vehicle safety standard 205 - glazing materials. The quarter panel glass windows are labeled with the manufacturer’s model number “m-66” and “as2” instead of the correct number “m-131” and “as3”. Correction: a production change has been undertaken to remedy these technical non-compliance conditions. No corrective recall action is required as the technical non-compliance conditions are deemed to be non-safety related.

  Show Content

• Recall 2014525 [Canada]: Seats and restraints
  On certain vehicles, the lap end attachment fastener on the front passenger seat belt may not have been torqued to proper specification. If the tightening torque of the fastener is too low, road vibrations could cause the fastener to loosen further. If this were to occur, the fastener may not properly restrain the front passenger occupant in the event of a crash, which could increase the risk of injury to the seat occupant in a crash. Correction: dealers will inspect the torque value of the front passenger seat belt lap end attachment, and correct as necessary.

  Show Content

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.