Nova Bus Nova Lfs 2006

Vehicle Details: Recalls, Service Bulletins

Below you will find all available information on the 2006 NOVA BUS Nova Lfs.

ManufacturerKnown WMI(s)Fuel Type
NOVA BUS
NOVA BUS VIN Decoder

Use the box here to look up VINs from NOVA BUS as well as other manufacturers

#
Frequently Asked Questions
  • Are there recalls for the 2006 NOVA BUS Nova Lfs?
     - There are 15 recall(s) for the 2006 NOVA BUS Nova Lfs, additional information is below.
NHTSA Mandated Recalls
  • Recall 106529 [USA]: If the rear exit door does not open and close as expected, there is an increased risk of injury to bus occupants.

  • Recall 107398 [USA]: The incorrectly positioned retaining ring may allow the air line to detach, compromising the rear axle braking performance and increasing the risk of a crash.

  • Recall 104347 [USA]: If the abs malfunction light does not illuminate if the abs control unit loses power, the driver would not be aware that the abs is not functional and that the brakes may unexpectedly lock up under certain conditions when the brakes are applied, increasing the risk of crash.

  • Recall 67811 [USA]: A short could occur, possibly causing smoke and fire.

  • Recall 72776 [USA]: The introduction of high pressure atomized fuel into the engine compartment creates a risk of fire due to possible ignition when the fuel vapor comes in contact with hot surfaces.

  • Recall 2018456 [Canada]: Seats and restraints

  • Recall 2015064 [Canada]: Brakes

  • Recall 2014262 [Canada]: Brakes

  • Recall 2009050 [Canada]: Electrical

  • Recall 2009349 [Canada]: Other

  • Recall 2008133 [Canada]: Other

  • Recall 2008146 [Canada]: Electrical

  • Recall 2007121 [Canada]: Brakes

  • Recall 2006182 [Canada]: Heater and defroster

  • Recall 2022248 [Canada]: Lights and instruments

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • LI5170E - SUSPENSION: New lower shock mount available with an adapter plate better suited for the front and rear axle.
  • LI5179R1 - SERVICE BRAKES, AIR: Installation of new pressure regulator for retarder interlock. Obsolete part replacement
  • LI5178R1 - SERVICE BRAKES, HYDRAULIC: Installation of new pressure regulator for retarder interlock. Obsolete part replacement
  • LI5179 - SERVICE BRAKES, AIR: Installation of new pressure regulator for interlock retarder. Obsolete part replacement
  • LI5180 - SERVICE BRAKES, AIR: Installation of new pressure regulator for interlock retarder. Obsolete part replacement.
  • LI3978E - EQUIPMENT: Information about the engine coolant. Coolant types should not be mixed in the engine.
  • LI5011E - EQUIPMENT: Recommendations on the disinfection of vehicles as well as products and precautions to be taken.
  • LI4956E - FUEL SYSTEM, GASOLINE: The auxiliary heater fuel filter is now obsolete. The fuel filter and its support will have to be replaced at its next maintenance.
  • LI4432ER1 - STEERING: Trw has eliminated from service procedure tas-103 the greasing of the steering gearbox output shaft.
  • APS4896E - STEERING: Introduction of a new steering gearbox without the lubrication zerk.
  • LI4577ER1 - EQUIPMENT: The repair kit parts will require a specific installation procedure. Current stock parts may still be used
  • LI4546E - UNKNOWN OR OTHER: To avoid the risk of air being trapped which could damage the egr cooler.
  • LI4126E - ENGINE AND ENGINE COOLING: N64662 pal hydraulic filter head is discontinued and replaced by hydraulic filter head n8905938 and filter n8905939.
  • LI3402ER3 - ENGINE AND ENGINE COOLING:COOLING SYSTEM: Low coolant level sensor warning
  • LI3188 - SUSPENSION: A new radius rod bolt torque is now in effect.
  • LI2116E - SERVICE BRAKES, AIR:DISC: Diagnose a potentiel bendix disk brake thermal overload.
  • LI3402ER1 - ENGINE AND ENGINE COOLING: Low coolant level sensor warning
  • LI3402ER2 - ENGINE AND ENGINE COOLING: Low coolant level sensor warning
  • BS3419E - VISIBILITY:WINDSHIELD WIPER/WASHER:MOTOR: The wiper motor cannot be stopped by the driver.
  • LI1841ER3 - EXTERIOR LIGHTING:HEADLIGHTS: Repair procedure of the front beam box
  • LI1911ER1 - EQUIPMENT: Zf wheel head suspension. Zf introduced an optimized axial roller bearing. Replace the axial roller bearing and lower seal ring with an optimized roller bearing.
  • LI1806ER2 - FUEL SYSTEM, OTHER:STORAGE:TANK ASSEMBLY: Structural stress may cause crack on hydraulic tank's support n54479 and n54299
  • LI1953E - STEERING:HYDRAULIC POWER ASSIST SYSTEM: Moisture may accumulate in the space under the driver's seat and cause corrosion of the power steering hydraulic fittings and piping.
  • LI3402E - ENGINE AND ENGINE COOLING: Low coolant level sensor warning
  • LI3446ER2 - STEERING:GEAR BOX:SHAFT PITMAN: Introducing new hardware and installation procedure for pitman arm. (r2 revision is for: road number and vin has been updated for l860 ttc)
  • li3478er1 - ELECTRICAL SYSTEM:SOFTWARE: Incompatibility of actia gauge programs a fault may appear on the actia gauge if an incorrect program version is used (r1 modifications: speedo sw 109633v08_00 changed to 109633v08_02 for atuq. For ttc speedo sw 116724v04_35 changed to 11
  • li3446er5 - STEERING:GEAR BOX:SHAFT PITMAN: Introducing new hardware and installation procedure for pitman arm. (r5 updated the torque value in procedure line 1.9)
  • BS3512E - ELECTRICAL SYSTEM:SOFTWARE: This communication is a service bulletin concerning a fault that may appear on the actia gauge if an incorrect program version is used
  • LI3478ER1 - ELECTRICAL SYSTEM: "incompatibility of actia gauge programs a fault may appear on the actia gauge if an incorrect program version is used (r1 modifications: speedo sw 109633v08_00 changed to 109633v08_02 for atuq. For ttc speedo sw 116724v04_35 changed to 1
  • LI3446ER5 - SUSPENSION: Introducing new hardware and installation procedure for pitman arm. (r5 updated the torque value in procedure line 1.9)
  • LI3446ER4 - STEERING: Introducing new hardware and installation procedure for pitman arm.

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.