2010 PETERBILT 220Peterbilt 220 2010

Vehicle Details: Recalls, Service Bulletins

Below you will find all available information on the 2010 PETERBILT 220, manufacturered by Peterbilt Motors Company.

ManufacturerKnown WMI(s)Fuel Type
PETERBILT1NP 1XP 2NP 2XP 3BP 3WP
PETERBILT VIN Decoder

Use the box here to look up VINs from PETERBILT as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 2010 PETERBILT 220 produced?
     - The 2010 PETERBILT 220 is produced in Denton Tx, United States (usa).
  • Are there recalls for the 2010 PETERBILT 220?
     - There are 1 recall(s) for the 2010 PETERBILT 220, additional information is below.
NHTSA Mandated Recalls

  • Recall 126485 [USA]: If the sway bar link detaches and falls into the drag link, it may impact the ability of the vehicle to steer properly, increasing the risk of a crash.

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Recalls are also available on the Complaints page
Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • 02-160 - EQUIPMENT ADAPTIVE/MOBILITY: Information only a?? Windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
  • 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
  • 43-067 - STRUCTURE: Fix as fail: for all conventional models, except 387/587, equipped with side-of-cab (⿿soc⿝) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the soc exhaust stacks may not be tightened properly. This may allow the
  • 11-001 - POWER TRAIN: Information only: hendrickson softek front axle maintenance intervals and requirements.
  • 34-085 - ELECTRICAL SYSTEM: Information only a?? Vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
  • 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
  • 34-085 - ELECTRICAL SYSTEM: Information only: vehicles may have the connector seal on the wheel speed sensor incorrectly installed, which may lead to sensor corrosion.
  • 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
  • 34-066 - ELECTRICAL SYSTEM: Information only - quick reference guide for electric harness damage repairs.
  • 34-077 - EQUIPMENT:ELECTRICAL: Information only: proper instructions for closure of power distribution box cover to prevent corrosion.
  • 13-049 - ELECTRICAL SYSTEM:SOFTWARE: Information: bendix acom software version 6.16.5.0 for diagnostics may introduce an unrecoverable error. Notice to dealers to replace this version with older software version until bendix introduces new version.
  • 03-064 - ELECTRICAL SYSTEM: Information - recommended practices for updating esa software

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.