2014 PETERBILT 365Peterbilt 365 2014

Vehicle Details: Recalls, Decoded VIN Details, Service Bulletins

Below you will find all available information on the 2014 PETERBILT 365, manufacturered by Peterbilt Motors Company.
The vehicle is described as a 6x4 Single-unit straight truck or Cab-Chassis (GVWR greater than 26,000 lbs.).

ManufacturerKnown WMI(s)Fuel Type
PETERBILT3WP
PETERBILT VIN Decoder

Use the box here to look up VINs from PETERBILT as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 2014 PETERBILT 365 produced?
     - The 2014 PETERBILT 365 is produced in Denton Texas, United States (usa).
  • Are there recalls for the 2014 PETERBILT 365?
     - There are 20 recall(s) for the 2014 PETERBILT 365, additional information is below.
  • What is the GVWR of a 2014 PETERBILT 365?
     - The 2014 PETERBILT 365 has a GVWR of Class 8: 33,001 lb and above (14,969 kg and above) lbs.
NHTSA Mandated Recalls
  • Recall 146590 [USA]: If the driver unknowingly operates the vehicle without the abs functioning, there would be an increased risk of a crash.

  • Recall 105905 [USA]: Higher vehicle speeds and other factors such as tire load and road temperatures may result in premature tire failure, increasing the risk of a crash.

  • Recall 117975 [USA]: If the alternator cable rubs through its insulation, an electrical short may occur, increasing the risk of a fire.

  • Recall 111036 [USA]: If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

  • Recall 117244 [USA]: If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (gvwr) load listed without experiencing tire failure which would increase the risk of a crash.

  • Recall 109471 [USA]: Undertorqued tie rod end clamp bolts are susceptible to corrosion, which may cause loose bolts to separate resulting in a loss of vehicle control and an increased risk of a crash.

  • Recall 104271 [USA]: Without a warning of a problem existing in the side air bag system, the driver may continue to operate the vehicle, increasing the risk of injury from the side air bag not deploying in the event of a rollover.

  • Recall 101619 [USA]: The improper operation of the sensor could induce elevated exhaust temperatures or flames from the exhaust pipe, increasing the risk of a vehicle fire or burn injury to a person near the exhaust pipe.

  • Recall 100783 [USA]: If the latch plate remains partially engaged after the button is pressed, egress from the vehicle could be hindered which would increase the risk of injury in the event of an emergency.

  • Recall 96493 [USA]: Unintended engine startup could cause injury to a person working in the engine compartment. vehicles with standard transmissions may experience unexpected movement, which may result in personal injury or a crash.

  • Recall 2020148 [Canada]: Lights and instruments

  • Recall 2015531 [Canada]: Tires

  • Recall 2015317 [Canada]: Electrical

  • Recall 2015211 [Canada]: Engine

  • Recall 2015095 [Canada]: Label

  • Recall 2015078 [Canada]: Steering

  • Recall 2014198 [Canada]: Airbag

  • Recall 2014046 [Canada]: Engine

  • Recall 2014020 [Canada]: Seats and restraints

  • Recall 2013178 [Canada]: Electrical

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • 13-060 - BRAKES (PWS): The service information for bendix air dryer maintenance is being updated to include new procedures.
  • E271 - ENGINE AND ENGINE COOLING: An engine software update is required to resolve obd system readiness, def doser diagnostics, and otherobd system software related issues.
  • 02-160 - EQUIPMENT: Information only ⿿ windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
  • 02-158 - ELECTRICAL SYSTEM:12V/24V/48V BATTERY: Fix as fail: peterbilt has determined that certain model 348, 365, 367, 382, 384, 386, 388, 389, 567, 579, and 587 trucks, built between 4/13/2010 and 3/16/2020 and equipped with a flush mounted battery box, utilized rubber washers that co
  • 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
  • 43-067 - STRUCTURE: Fix as fail: for all conventional models, except 387/587, equipped with side-of-cab (a??Soca??) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the soc exhaust stacks may not be tightened properly. This may allow the
  • 11-001 - POWER TRAIN: Information only: hendrickson softek front axle maintenance intervals and requirements.
  • 18PBB - EQUIPMENT ADAPTIVE/MOBILITY: Safety recall bulletin: updated with permanent repair path for phase 1 vehicles. The tractor abs lamp may not illuminate when abs controller loses battery and/or ignition power. Nhtsa recall number is 18v368. Non compliance to fmvss and
  • 20 PBC - SERVICE BRAKES, HYDRAULIC:ANTILOCK/TRACTION CONTROL/ELECTRONIC LIMITED SLIP:ABS WARNING LIGHT: Safety recall interim bulletin: the tractor abs lamp may not illuminate when abs controller loses battery and/or ignition power. Nhtsa recall number is 20v199 non compliance to fmvss and cmvss 121 and 136. Resolution is to reflash softwa
  • 34-085 - VEHICLE SPEED CONTROL: Information only a?? Vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
  • 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
  • 34-085 - ELECTRICAL SYSTEM: Information only: vehicles may have the connector seal on the wheel speed sensor incorrectly installed, which may lead to sensor corrosion.
  • 03-071 - ELECTRICAL SYSTEM:SOFTWARE: Information only - vehicles built with namux software from 2013 to present may experience accuracy issues with the tachometer. The issue can be temporarily resolved using any one of the included procedures.
  • 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
  • 16-041 - SUSPENSION: Non safety campaign: peterbilt has determined that certain model 365, 384, 386, 388, 389, 3895, 587 and 579 vehicles built between march 27, 2012 and january 20, 2019 with flex air suspension in a 6x2 configuration have u-bolts that may fa
  • TIB43-062 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Information only â¿¿ this bulletin provides information about the california air resources board (carb) periodic smoke inspection program (psip) and heavy duty vehicle inspection program (hdvip).
  • 42-058 - ENGINE AND ENGINE COOLING: Fix-as-fail: two separate causes have been identified as root cause of intermittent low coolant indicator illumination.
  • 34-066 - ELECTRICAL SYSTEM: Information only - quick reference guide for electric harness damage repairs.
  • 34-077 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Information only: proper instructions for closure of power distribution box cover to prevent corrosion.
  • 13-049 - ELECTRICAL SYSTEM:SOFTWARE: Information: bendix acom software version 6.16.5.0 for diagnostics may introduce an unrecoverable error. Notice to dealers to replace this version with older software version until bendix introduces new version.
  • 03-064 - ELECTRICAL SYSTEM: Information - recommended practices for updating esa software
  • 7-17 - WHEELS: Fix-as-fail ? There is an updated plug to fix leaking steer axle hubcaps.
  • 16-16 - ENGINE (PWS): Fix-as-fail: updated procedure for models with engine-overspeed warning brought to dealership.
  • RN-714-1 - POWER TRAIN:MANUAL TRANSMISSION: Peterbilt: see document search button for owner letter. Certain trucks, at time of assembly, may not have a properly seated upper reverse idler feed tube (oil supply line), resulting in bearings having reduced oil pressure. *pe
  • SB-E-097 - ENGINE (PWS): Peterbilt: the malfunction indicator lamp (mil) illuminates due to an engine control unit (ecu) software issue, rear nox sensor, operating correctly. *pe
NHTSA decoded information from VIN

138 Results returned successfully. NOTE: Any missing decoded values should be interpreted as NHTSA does not have data on the specific variable. Missing value should NOT be interpreted as an indication that a feature or technology is unavailable for a vehicle.

Variable Value
Body ClassTruck
Brake System TypeAir
Drive Type6x4
Engine ManufacturerCummins
Engine ModelISX 11.9/12
Error Text0 - VIN decoded clean. Check Digit (9th position) is correct
GVWRClass 8: 33,001 lb and above (14,969 kg and above)
MakePETERBILT
MakeID495
ManufacturerPETERBILT MOTORS COMPANY
Manufacturer Id1033
Model365
ModelID2790
Model Year2014
NCSA Body TypeSingle-unit straight truck or Cab-Chassis (GVWR greater than 26,000 lbs.)
NCSA MakePeterbilt
NCSA ModelMedium/Heavy - CBE
Plant CityDENTON
Plant Company NamePeterbilt
Plant CountryUNITED STATES (USA)
Plant StateTEXAS
VIN1NPSL70X7ED228642
Vehicle TypeINCOMPLETE VEHICLE
Latest VINs Decoded for this Manufacturer
VIN Year Model Manufactured In
1NPSX7TX9ED2309262014365DENTON TEXAS, UNITED STATES (USA)
1NPSLP0X0ED2253242014365DENTON TEXAS, UNITED STATES (USA)
1NPSLP0X7ED2225172014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X7ED2286422014365DENTON TEXAS, UNITED STATES (USA)
1NPSXPEXXED2329252014365DENTON TEXAS, UNITED STATES (USA)
1NPSLP0X6ED2501292014365DENTON TEXAS, UNITED STATES (USA)
1NPSL79X1ED2445642014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X4ED2229582014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X8ED2274182014365DENTON TEXAS, UNITED STATES (USA)
1NPSLP0X3ED2249442014365DENTON TEXAS, UNITED STATES (USA)
1NPSXPEX6ED2355802014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X1ED2332712014365DENTON TEXAS, UNITED STATES (USA)
1NPSLJ0X6ED2476782014365DENTON TEXAS, UNITED STATES (USA)
1XPSDP9X3ED2249202014365DENTON TEXAS, UNITED STATES (USA)
1NPSLJ0X5ED2476862014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X4ED1752222014365DENTON TEXAS, UNITED STATES (USA)
1NPSXHEX5ED2445352014365DENTON TEXAS, UNITED STATES (USA)
1XPSDP9X1ED2510022014365DENTON TEXAS, UNITED STATES (USA)
1NPSLJ0X4ED2267502014365DENTON TEXAS, UNITED STATES (USA)
1NPSLP0X8ED2399422014365DENTON TEXAS, UNITED STATES (USA)
1NPSLH0X9ED2474902014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X8ED1760172014365DENTON TEXAS, UNITED STATES (USA)
1NPSX7EXXED2493192014365DENTON TEXAS, UNITED STATES (USA)
1NPSL70X1ED2142212014365DENTON TEXAS, UNITED STATES (USA)

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.