2010 PETERBILT 382Peterbilt 382 2010

Vehicle Details: Recalls, Investigations, Service Bulletins

Below you will find all available information on the 2010 PETERBILT 382, manufacturered by Paccar Inc..

ManufacturerKnown WMI(s)Fuel Type
PETERBILTSBV
PETERBILT VIN Decoder

Use the box here to look up VINs from PETERBILT as well as other manufacturers

#
Frequently Asked Questions
  • Where is the 2010 PETERBILT 382 produced?
     - The 2010 PETERBILT 382 is produced in Bellevue Wa, United States (usa).
  • Are there recalls for the 2010 PETERBILT 382?
     - There are 4 recall(s) for the 2010 PETERBILT 382, additional information is below.
NHTSA Mandated Recalls
  • Recall 111065 [USA]: If engine oil comes into contact with a hot surface, there is an increased risk of a fire.

  • Recall 117342 [USA]: If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (gvwr) load listed without experiencing tire failure which would increase the risk of a crash.

  • Recall 2015211 [Canada]: Engine

  • Recall 2015095 [Canada]: Label

To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.

Bulletins

Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.

  • 02-160 - EQUIPMENT ADAPTIVE/MOBILITY: Information only a?? Windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
  • 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
  • 43-067 - STRUCTURE: Fix as fail: for all conventional models, except 387/587, equipped with side-of-cab (⿿soc⿝) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the soc exhaust stacks may not be tightened properly. This may allow the
  • 11-001 - POWER TRAIN: Information only: hendrickson softek front axle maintenance intervals and requirements.
  • 34-085 - ELECTRICAL SYSTEM: Information only a?? Vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
  • 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
  • 34-085 - ELECTRICAL SYSTEM: Information only: vehicles may have the connector seal on the wheel speed sensor incorrectly installed, which may lead to sensor corrosion.
  • 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
  • 34-066 - ELECTRICAL SYSTEM: Information only - quick reference guide for electric harness damage repairs.
  • 34-077 - EQUIPMENT:ELECTRICAL: Information only: proper instructions for closure of power distribution box cover to prevent corrosion.
  • 13-049 - ELECTRICAL SYSTEM:SOFTWARE: Information: bendix acom software version 6.16.5.0 for diagnostics may introduce an unrecoverable error. Notice to dealers to replace this version with older software version until bendix introduces new version.
  • 03-064 - ELECTRICAL SYSTEM: Information - recommended practices for updating esa software
Known Recall Investigations
  • Intermittent loss of power steering assist investigation # PE20006

    On may 1, 2020, the office of defects investigation (odi) opened pe20006 to investigate complaints of intermittent loss of power steering assist in daimler truck north america (dtna), volvo trucks of north america (volvo) and paccar vehicles equipped with a zf/trw (trw) thp60 steering gear.  the investigation focused on 2010-2020 dtna freightliner cascadia, m2 and wst; volvo vn, vah and vhd and paccar 337, 365, 389, 567, 579 model vehicles.Field reports and interviews with fleet drivers allege that high power steering fluid temperatures could result in internal seal and bearing failures causing pressure fluctuation, affecting left and right-hand turns.  the inability of the driver to steer the vehicle as intended can increase the risk of a crash and injury. Odi analyzed data provided by trw, dtna, volvo, and paccar in response to individual information request letters.Odi found that most failures occurred within the first two years and/or 50,000 miles of service.  the claim rate decreased with time and miles in service and remained less than 0.5%. Odi normalized data from each of the manufacturers and determined that there was not a substantial difference in the failures.Additionally, trw improved a seal in the steering gear in december 2015.Trucks built on or after 2016 (as 2017 and newer model years) show a decreasing trend of failures. In view of the overall low failure rate, the nature of early-life failure, and failure rate trending downward for model years 2017 and newer, this preliminary evaluation (pe) is closed.  the closing of this investigation does not constitute a finding by nhtsa that a safety-related defect does not exist.The agency reserves the right to take additional action if warranted by future circumstances. To review the odi reports cited in the closing resume odi report identification number document, go to nhtsa.Gov.

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.