Peterbilt 385 2014
Vehicle Details: Recalls, Service Bulletins
PETERBILT VIN Decoder
Use the box here to look up VINs from PETERBILT as well as other manufacturers
Frequently Asked Questions
-
Where is the 2014 PETERBILT 385 produced?
- The 2014 PETERBILT 385 is produced in Denton Tx, United States (usa).
-
Are there recalls for the 2014 PETERBILT 385?
- There are 2 recall(s) for the 2014 PETERBILT 385, additional information is below.
NHTSA Mandated Recalls
Recall 117378 [USA]: If the tires are underinflated due to the incorrect inflation pressure listed on the label, the truck may not be able to carry the maximum gross vehicle weight rating (gvwr) load listed without experiencing tire failure which would increase the risk of a crash.
Recall 2015095 [Canada]: Label
To ensure accuracy and for your safety, it is recommended to do a free VIN recall check here or here [USA] - UK - Canada.
Bulletins
Bulletins are notices put out by manufacturers in conjunction with the NHTSA to notify the public of manufacturing issues or changes.
- 13-060 - BRAKES (PWS): The service information for bendix air dryer maintenance is being updated to include new procedures.
- 02-160 - EQUIPMENT ADAPTIVE/MOBILITY: Information only a?? Windshield washer pumps have a high no trouble found rate. Washer pumps may fail to spray due to a clogged filter.
- 32-015 - ELECTRICAL SYSTEM: Information only: this bulletin provides dealers with a battery warranty quick reference guide to ensure the appropriate tests for battery warranty are performed in order to prevent battery warranty claims filed with incorrect or incomplet
- 43-067 - STRUCTURE: Fix as fail: for all conventional models, except 387/587, equipped with side-of-cab (a??Soca??) exhaust and built from 03/6/2006 to 1/20/2020, the clamps that secure the soc exhaust stacks may not be tightened properly. This may allow the
- 11-001 - POWER TRAIN: Information only: hendrickson softek front axle maintenance intervals and requirements.
- 34-085 - ELECTRICAL SYSTEM: Information only ⿿ vehicles may have the connector seals on the wheel speed sensor incorrectly installed, which may lead to water intrusion and corrosion in some vehicles.
- 32-016 - EQUIPMENT: Information only: proper jump-starting voltage will eliminate high voltage related issues and equipment damage.
- 34-085 - VEHICLE SPEED CONTROL: Information only: vehicles may have the connector seal on the wheel speed sensor incorrectly installed, which may lead to sensor corrosion.
- 03-071 - ELECTRICAL SYSTEM:SOFTWARE: Information only - vehicles built with namux software from 2013 to present may experience accuracy issues with the tachometer. The issue can be temporarily resolved using any one of the included procedures.
- 01-075 - ENGINE AND ENGINE COOLING: Information only: this bulletin provides guidance for repairing an air-conditioning system after internal failure of the a/c compressor.
- TIB43-062 - ENGINE AND ENGINE COOLING:EXHAUST SYSTEM: Information only ??A?A? This bulletin provides information about the california air resources board (carb) periodic smoke inspection program (psip) and heavy duty vehicle inspection program (hdvip).
- 42-058 - ENGINE AND ENGINE COOLING: Fix-as-fail: two separate causes have been identified as root cause of intermittent low coolant indicator illumination.
- 34-066 - ELECTRICAL SYSTEM: Information only - quick reference guide for electric harness damage repairs.
- 34-077 - EQUIPMENT:OTHER:OWNERS/SERVICE/OTHER MANUAL : Information only: proper instructions for closure of power distribution box cover to prevent corrosion.
- 13-049 - ELECTRICAL SYSTEM:SOFTWARE: Information: bendix acom software version 6.16.5.0 for diagnostics may introduce an unrecoverable error. Notice to dealers to replace this version with older software version until bendix introduces new version.
- 03-064 - ELECTRICAL SYSTEM: Information - recommended practices for updating esa software
- 7-17 - WHEELS:HUB: Fix-as-fail ? There is an updated plug to fix leaking steer axle hubcaps.