PIT-4898
Service Bulletin Details
Public Details for: PIT-4898
Chevrolet: the sir light is on with dtc's. The driver's power seat is inoperative and/or the sir light is coming on intermittently. *pe updated 5/25/11. *pe updated 2/1/16. *pe
- 2010 -
Models from 2010
2010 CHEVROLET EQUINOX |
SB-10032406-3849 SB-10032406-9492 SB-10032406-2175 File in Section: Service Bulletin Bulletin No.: Date: PIT4898C August, 2015 PRELIMINARY INFORMATION Subject: The Drivers Power Seat Inoperative or SIR Light Is On With DTCs B0014 B0015 B0021 Models: 2010 Chevrolet Equinox This PI was superseded to edit Subject. Please discard PIT4898B. The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI. Condition/Concern 2321545 In rare cases, customers may complain that the driver's power seat is inoperative and/or the SIR light is coming on intermittently. When diagnosing the vehicle, DTC's B0014 and/or B0015 may be found in the SDM. The "PWR SEAT LT" fuse may be open in the underhood fuse block. This may be caused by a wire harness getting pinched under the driver's seat, between the seat frame and the power seat motor (see picture above). This concern happens when the seat is moved to the up position. This is applicable for both 4 and 8 way power seats. Recommendation/Instructions 2462212 Check the wire harness under the seat for contact between the seat frame and the power seat motor Picture shown is viewing the driver’s seat from underneath (passengers seat similar). If any wires are found to be damaged, repair them as necessary. For repair information regarding X308 and X310 see the latest version of 14710: Special Coverage Adjustment - Illumination of Airbag Readiness Light/Service Airbag Message On vehicles equipped with 4 way seats, drivers side seat wiring to switch can become pinched and or chafe on side shield bracket. This can add more pressure from the harness to the seat switch and damage the seat switch. This condition occurs when the seat is in the full down position. 2526551 Add abrasion tape and or wiring conduit to harness in this area. Additionally, file burr smooth. Driver side 8 way power seat pre-tensioner branch/connection in tension when seat is in full up position. May cause air bag code to set. Tension at connector may cause broken/pulled out wires at connector 2526555 Reposition the wire harness branch 10mm to 20mm for more slack. Pretensioner/Lumbar branch on drivers side 8 way power seat may become pinched or trapped under outboard side bracket. 2526558 Add conduit or equivalent protective covering wire harness Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed.