13-EE-002
Service Bulletin Details
Public Details for: 13-EE-002
Summary to be provided on a future date.
Models from 2012
2012 HYUNDAI SANTA FE |
Models from 2011
2011 HYUNDAI SANTA FE |
Models from 2010
2010 HYUNDAI SANTA FE |
@) HYUnDRI I NUMBER GROUP nEWTHlnKlnG. nEW POSSIBILITIES. Technical Service Bulletin ELECTRICAL 13-EE-002 MODEL(S) DATE JUNE 2013 Santa Fe (CM) OVERHEAD CONSOLE LAMP REPAIR SUBJECT: Description: This bulletin provides the procedure to repair overhead console lamps in some 2010-2012MY Santa Fe vehicles . Do not replace the overhead console lamp assembly when the condition below exists . Instead , follow the repair procedure and replace the related part. Symptoms: • Overhead lamps may not turn on when doors are open . When this condition is confirmed, replace the overhead console lamp circuit board as described in this bulletin . Overhead console lamp assembly Circuit Board Applicable Vehicles: • 2010-2012MY Santa Fe (CM) 2.4 I 3.5L Parts Information: Model Production Date Part Name July 7, 2008 October 31 , 2009 Santa Fe (CM) W/ Sunroof Circuit Board October 5, 2009 August 30 , 2010 Interior Color Part Number Beige 92807-0W700 J9 Gray 92807-0W700 J4 Beige 92807-0W700 SH Gray 92807-0W700 TX Quantity 1 Circulate To : General Manager, Service Manager, Parts Manager, Warranty Manager, Service Advisors , Technicians , Body Shop Manager, Fleet Repair OVERHEAD CONSOLE LAMP REPAIR SUBJECT: July 7, 2008 October 31 , 2009 Santa Fe (CM) W/O Sunroof Beige 92807-0W600 J9 Gray 92807-0W600 J4 Beige 92807-0W600 SH Gray 92807-0W600 TX 1 Circuit Board October 5, 2009 August30,2010 Warranty Information: Model CM Op Code Operation Overhead Console 92807ROO Circuit Board Replacement Op Time Causal Part# Nature Code Cause Code 0.3 See parts information N94 C15 Tools Required: • • Philips-head screwdriver Trim removal tool (or suitable prying tool) Service Procedure: 1. Flip open the sunglasses holder and remove the 2 screws. Slide overhead console towards the windshield and disconnect connector (8) . TSB #: 13-EE-002 [:>: Scraw locaOO.na, 2 Page 2 of 3 OVERHEAD CONSOLE LAMP REPAIR SUBJECT: 2. Remove the 4 screws holding the circuit board to the overhead console . Unclip 2 plastic retaining clips using a trim removal tool and remove the circuit board from the overhead console . Clip 3. Snap new circuit board assembly into the overhead console. 4. Tighten 4 screws securing the circuit board to the overhead console . 5. Install overhead console into vehicle by following reverse of removal. 6. Check for proper operation of sunglass holder, map lamp and sunroof (if equipped). TSB # : 13-EE-002 Page 3 of 3