L-SB-0090-13

©•
December 3, 2013
L-SB-0090-13
F'Xl IS
Technical Service Information Bulletin
Front License Plate & Mounting Bracket Installation
Service
Category
General
Section
Pre-Delivery Service
Lexus Supports
-
Market
~
ASE Certification-
USA
Applicab ility
YEAR(S)
MODEL(S)
2014
CT200H
ADDITIONAL INFORMATION
Introduction
The front license plate mounting bracket and two self-tapping screws for the 2014 model
year CT 200h are placed in the luggage compartment of the vehicle at the assembly plant.
For states that require a front license plate, install the bracket and bolts on the bumper cover during
Pre-Delivery Service (PDS) accordi ng to the following procedures.
Warranty Information
OP CODE
N/A
DESCRIPTION
TIME
O FP
T1
T2
Not Applicable to Warranty
-
-
-
-
© 2013 Lexus , a division of Toyota Motor Sales, USA
Page 1 of 3
L-SB-0090-13
December 3, 2013
Page 2 of 3
Front License Plate & Mounting Bracket Installation
Installation Procedure
1. Align holes "A" of the mounting bracket with the
dimples on the front bumper cover. Mark the
location of holes "B" on the front bumper cover.
Figure 1.
NOTE
• Holes "A" are used to install the mounting
bracket to the bumper cover.
• Holes "B" are used for installation of the
front license plate to the mounting bracket.
\
-~ll
1
Mounting Bracket
2
Dimples
3
Mark and Drill Holes
2. Drill two relief holes with a diameter of 11 mm (0.43 in.) at the marks on the front bumper cover
(holes "B" location) to prevent the license plate retaining bolt ends from contacting the cover.
NOTE
Do NOT drill into the dimples on the front bumper cover.
© 2013 Lexus, a division of Toyota Motor Sales, USA
L-SB-0090-13
December 3, 2013
Page 3 of 3
Front License Plate & Mounting Bracket Installation
Installation Procedure (Continued)
3. Install the mounting bracket to the front bumper
cover at holes "A" using the two supplied
self-tapping screws.
Figure 2. Mounting Bracket
1
l
Self-Tapping Screws into Holes "A"
4 . Install the front license plate to the mounting
Figure 3. License Plate
bracket at holes "B" using two non-corroding bolts .....---------- - -- - -- ----.
with the following dimensions.
Nominal Length: 15.0 mm (0.59 in.)
Diameter: 6.0 mm (0.24 in.)
1
2
I
Front License Plate
Bolts
Figure 4.
© 2013 Lexus, a division of Toyota Motor Sales, USA