L-SB-0099-14

©• FXI IS
November 10, 2014
L -SB-0099-14
Technical Service Information Bulletin
Front License Plate and Mounting Bracket Installation
Service
Category
General
Lexus Supports
Section
Pre-Delivery Service
Market
~
ASE Certification.
USA
Applicability
YEAR(S)
MODEL(S)
2015
NX200T, NX300H
ADDITIONAL INFORMATION
Introduction
The front licen se plate mounting bracket and 2 self-tapping screws for the 2015 model year
NX 200U300h are stored in the rear cargo area of the vehicle. Install the license plate and mounting
bracket during Pre-Delivery Service (PDS).
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
-
-
-
-
© 201 4 Lexus, a division of Toyota Motor Sales, USA
Page 1 of 3
L-SB-0099-14
November 10, 2014
Page 2 of 3
Front License Plate and Mounting Bracket Installation
Installation Procedure
1. Install Mounting Bracket.
Figure 1.
A. Align holes "A" of the mounting bracket with
the dimples on the radiator lower grille.
B
t
HINT
• Holes " A" are used to install the
mounting bracket to the bumper cover.
CD
0
A
• Holes " B " are used to install the front
license plate to the mounting bracket.
B. Engage the two clips and screw the two
supplied self-tapping screws directly into
the dimples to install the front license plate
mounting bracket.
NOTICE
•
Do NOT pre-drill holes into the dimples
on the front bumper cover.
•
Do NOT over-tighten the self-tapping
screws.
1
Mounting B racket
2
Dimples
3
Self-t apping Screws
© 2014 Lexus, a division of Toyota Motor Sales, USA
B
°1J' ~
A
L-SB-0099-14
November 10, 2014
Front License Plate and Mounting Bracket Installation
Installation Procedure (Continued)
2. Install the front license plate to the mounting
bracket using 2 non-corroding bolts with the
following dimensions:
Figure 2.
Nominal Length: 15.0 mm (0.59 in .)
Diameter: 6.0 mm (0.24 in.)
1
I
Fro"t Uom• Pl•to
2
Bo lts
Figure 3.
1
2
I
Nominal Length
Diameter
© 201 4 Lexus, a division of Toyota Motor Sales, USA
Pag e 3 of 3