08-056-13REV.A

NUMBER:
GROUP:
DATE:
08-056-13 REV. A
Electrical
August 21, 2013
This bulletin is supplied as technical information only and Is not an authorization for repair. No part of this publication may be reproduced, stored in a retrie val system,
or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of Chrysler Group LLC.
THIS BULLETIN SUPERSEDES SERVICE BULLETIN 08-056-13, DATED July 30, 2013,
WHICH SHOULD BE REMOVED FROM YOUR FILES. ALL REVISIONS ARE
HIGHLIGHTED WITH **ASTERISKS** AND CHANGING THE BUILD DATES AND
REMOVING SMC SALES CODE.
THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE
TRANSMITTAL (RRT) 13-051 . ALL APPLICABLE SOLD AND UN-SOLD RRT VIN's
HAVE BEEN LOADED. TO VERIFY THAT THIS RRT SERVICE ACTION IS
APPLICABLE TO THE VEHICLE, USE VIP OR PERFORM A VIN SEARCH IN
TECHCONNECT. ALL REPAIRS ARE REIMBURSABLE WITHIN THE PROVISIONS OF
WARRANTY.
HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS
AVAILABLE BY SELECTING " HELP" THEN " HELP CONTENTS" AT THE TOP OF
THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
THE wiTECH SOFTWARE LEVEL MUST BE AT RELEASE 14.01 OR HIGHER TO
PERFORM THIS PROCEDURE.
SUBJECT:
Flash: Cluster Incorrectly Displays Suspension And Shifting Track
OVERVIEW:
This bulletin involves updating the Cab Compartment Node (CCN) software .
MODELS:
2013
(LC)
Challenger (SRT only)
NOTE: **This bulletin applies to vehicles Built on or after March 14 2013 (MOH
0314XX) on or before May 15, 2013 (MOH 0515XX)**.
SYMPTOM/CONDITION:
The customer may note when enabling sport mode the cluster will incorrectly display
"Suspension and Shifting TRACK (flag)". The cluster should display "Sport Mode ON".
DIAGNOSIS:
Using a Scan Tool (wiTECH) with the appropriate Diagnostic Proced ures available in
TechCONNECT, verify no DTC's are set. If DTCs are present record them on the repair
•
-2-
08-056-13 REV. A
order and repair as necessary before proceeding further with this bulletin.
If a customer's VIN is listed in VIP or your RRT VIN list, perform the repair. For all other
customers that describe the symptom/condition, perform the Repair Procedure.
REPAIR PROCEDURE:
NOTE: Install a battery charger to ensure battery voltage does not drop below 13.2
volts. Do not allow the charging voltage to climb above 13.5 volts during the
flash process.
NOTE: If this flash process is interrupted/aborted, the flash should be restarted.
1.
2.
Reprogram the CCN .
Flash reprogram the modules. Help using the wiTECH Diagnostic Application for
flashing the CCN is made available through the wiTECH Diagnostic Application . For
instructions select the "HELP" tab on upper portion of the wiTECH window, then
"HELP CONTENTS." This will open the Welcome to wiTECH Help screen where help
topics can be selected.
3. Clear any DTC's that may have been set in other modules due to reprogramming . The
wiTECH application will automatically present all DTCs after the flash and allow the
tech to clear them.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor
Operation
No:
Description
Skill Category
6 - Electrical and Body
18-19-45-98 Module, Cab Compartment
Node or (CCN) - Inspect and or Systems
Reprogram (1 - Semi-Skilled)
FAILURE CODE:
IFlash Module
Amount
0.2 Hrs.