JTB00275NAS1

TECHNICAL BULLETIN
JTB00275NAS1
12-DEC-12
SECTION: 501-00
Business / Picnic Tray Latch Broken
AFFECTED VEHICLE RANGE:
XJ (X351)
VIN:
Model Year:
V25520-V44088
2012-2013
CONDITION SUMMARY:
Situation: The Business / Picnic tray latch may be broken or the tray may not latch closed.
Cause: This may be caused by a stress riser on the molding due to an incorrect specification knurled pin.
Action: In the event of a customer concern of the above, refer to the Repair Procedure outlined below.
PARTS:
C2D13489XXX ........ Picnic tray latch
Qty: 1
TOOLS:
Refer to Workshop Manual for any required special tools
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change;
those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair
time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a
quantity of zero.
SRO
DESCRIPTION
Picnic tray latch - Pair - Renew
TIME
(HOURS)
76.14.16.02
0.20
CONDITION
CODE
01
CAUSAL
PART
C2D13489
Normal Warranty policies and procedures apply
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the j ob properly and safely. It informs these Technicians of c onditions that m ay occur on s ome vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not
a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to determine whether
this bulletin applies to a specific vehicle.
© Jaguar Land Rover North America, LLC
555 MacArthur Boulevard
Mahwah, NJ 07430
REPAIR PROCEDURE
1. Open the business tray.
2.
NOTE: If a washer is present behind the business
tray latch, it must be installed in the same position on
the new latch.
Remove the business tray latch.
•
3.
Remove the fixing.
NOTE: Make sure the latch is fully seated prior to
installing and tightening the fixing.
To install, reverse the removal procedure.
4. Carry out steps 1 to 3 to the opposite side business tray latch.