NTB14-058B

Classification:
Reference:
AT14-007b
Date:
NTB14-058b
April 21, 2016
2014-2016 ROGUE; SHIFT SELECTOR KNOB REMOVAL AND
INSTALLATION INCLUDING THE BLOCK-PULL AND SPRING
This bulletin has been amended. The APPLIED VEHICLES section has been revised.
Please discard previous versions of this bulletin.
APPLIED VEHICLES:
2014-2016 Rogue (T32)
NOTE: Does not apply to Rogue Select (S35)
SERVICE INFORMATION
This bulletin contains the procedure to remove and/or install the shift selector knob. It also
contains information for re-installing the block-pull and spring, if needed.
Removal
Shift
selector
knob
1. Apply the parking brake.
2. Pull DOWN the shift selector knob
cover (chrome finisher).
Retaining clip
3. Remove the retaining clip using a
suitable tool.
Shift selector
knob cover
(chrome finisher)
4. Pull the shift selector knob UP to
remove it.
Figure 1
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/3
5. Install the retaining clip back into the
shift selector knob.
Shift
selector
knob
Retaining clip
6. Slide the chrome finisher back into
place.
Chrome
finisher
7. Set the shift selector knob aside until
you are ready for installation.
Figure 2
NOTE:

See Block-pull and Spring Installation on the next page.

The block-pull and spring are exposed when the shift selector knob is removed.
Installation
Pull out the
shift selector
knob button,
and hold it out
1. Use a pick tool to pull out the shift
selector knob button, and hold it out.
2. While holding the button out, slide
the shift selector knob onto the shift
shaft until you feel it click into place.
3. Release the shift selector knob
button.
Figure 3
4. Pull UP on the shift selector knob to
make sure it is locked in place, and
does not come off.
2/3
NTB14-058b
Block-pull and Spring Installation
With the shift selector knob removed,
the block-pull and spring will be
exposed.
Block-pull
Opening at
bottom of
block-pull
If for any reason the block-pull and
spring are removed as shown in
Figure 5:
Spring

DO NOT replace the entire
shifter assembly if the bock-pull
and spring have been removed.

Make sure they are reinstalled
correctly, as shown in Figure 4.

The opening at the bottom of the
block-pull must be aligned with
the slot on the shift shaft as
shown in Figure 4.
Shift shaft
Slot on
shift shaft
Figure 4
Spring

Block-pull
Figure 5 shows the block-pull
and spring removed.
Shift shaft
Figure 5
3/3
NTB14-058b