NTB16-042

Classification:
Reference:
BT15-024
Date:
NTB16-042
April 12, 2016
2014-2015 TAXI; SLIDE DOOR WINDOW LATCH ASSEMBLY
SERVICE INFORMATION
APPLIED VEHICLES: 2014-2015 Taxi
SERVICE INFORMATION
The slide door window latch assembly for the applied vehicles listed above is now available
as a service part. If a slide door window latch assembly on an applied vehicle is being
replaced for any reason, refer to SERVICE PROCEDURE starting on page 2 for
replacement procedure.
Nissan Bulletins are intended for use by qualified technicians, not 'do-it-yourselfers'. Qualified technicians are
properly trained individuals who have the equipment, tools, safety instruction, and know-how to do a job
properly and safely. NOTE: If you believe that a described condition may apply to a particular vehicle, DO
NOT assume that it does. See your Nissan dealer to determine if this applies to your vehicle.
1/4
SERVICE PROCEDURE
Remove Slide Door Window Latch Assembly
1. Using a suitable tool, remove the upper and lower slide door window stops,
and then slide out the slide door window (see Figure 1).
Lower stop
Figure 1
2. Using a suitable trim tool, remove the
slide window latch finishers.
Finishers
Figure 2
2/4
NTB16-042
3. Remove the latch handle:
a. Push down on the latch pin, far
enough to be able to tilt the top end
of the latch handle.
b. Carefully tilt the top end of the latch
handle away from the window, and
then push the latch pin upward.
WARNING: Do not completely remove
the latch pin. It also holds a spring.
CAUTION: Do not tilt the latch more
than necessary.
c. Remove the latch handle by pulling
up.
Latch pin
Latch
handle
Figure 3
4. Depress each spring with a suitable tool,
and then remove the latch rod spring
retainers, one at a time.
Retainers
Springs
Figure 4
5. Using a suitable tool, release the latch
rods from the cam, and then remove the
latch rods and latch rod cam.
Cam
Rods
Figure 5
3/4
NTB16-042
Install Slide Door Window Latch
1. Install the slide door window latch assembly in reverse order of removal.
NOTE: For installation, the springs will need to be compressed in order to properly
reinsert the latch rod retainers.
PARTS INFORMATION
DESCRIPTION
PART NUMBER
QUANTITY
KNOB-SIDE DOOR WINDOW
1
82345-3LN0B*
(Latch rods and cam assembly)
* This part number is the same for both sides of the vehicle. One latch per order.
CLAIMS INFORMATION
Submit a Primary Part (PP) type line claim using the following claims coding:
DESCRIPTION
PFP
OP CODE SYM DIA FRT
RPL Slide Door Window Latch
(1)
US64AA
(2)
(2)
(3)
(1) Reference the Parts Information table and use the indicated Part number as the PFP.
(2) Use the Symptom and Diagnostic codes that apply to the repair actually performed.
(3) Reference the current Nissan Warranty Flat Rate Manual and use the indicated FRT.
4/4
NTB16-042