JTB00217NAS2

Service Bulletin Details

Public Details for: JTB00217NAS2

Situation: the rearmost section (in front of the rear wheel) of the rocker panel(s) may show signs of stone chipping.


- 2017 - 2015 - 2014 - 2013 - 2012 - 2011 - 2010 - 2009 -

Models from 2017
2017 JAGUAR F-PACE
2017 JAGUAR XE
Models from 2015
2015 JAGUAR XF
Models from 2014
2014 JAGUAR XF
Models from 2013
2013 JAGUAR XF
Models from 2012
2012 JAGUAR XF
Models from 2011
2011 JAGUAR XF
Models from 2010
2010 JAGUAR XF
Models from 2009
2009 JAGUAR XF 
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
TECHNICAL BULLETIN
JTB00217NAS2
31 AUG 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do­it­yourselfers'. If you
are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to
determine whether this bulletin applies to a specific vehicle.
This reissue replaces all previous versions. Please destroy all previous versions.
Changes are highlighted in gray
SECTION: 501­08
Rocker Panel Stone Chipping
AFFECTED VEHICLE RANGE:
XE (X760)
Model Year:
VIN:
Assembly
Plant:
XF (X250)
Model Year:
VIN:
Assembly
Plant:
2017 Onwards
942528 Onwards
Solihull
2009­2015
R00001­U88785
Castle Bromwich
MARKETS:
NAS
CONDITION SUMMARY:
Situation: The rearmost section (in front of the rear wheel) of the rocker panel(s) may show signs of stone chipping.
Cause: This may be caused by stones, from the front wheels, contacting the rocker panel.
NOTE: This Service Instruction is not applicable to the XE (X760) 'R­SPORT' or 'S' variants.
NOTE: This Service Instruction may not be submitted as a Warranty claim and is customer pay only.
Action: Should a customer express this concern, follow the Service Instruction outlined below.
PARTS:
T4N12869
Front Rocker Panel Tape L/H ­ XE (X760)
1
T4N12867
Front Rocker Panel Tape R/H ­ XE (X760)
1
T4N12870
Rear Rocker Panel Tape L/H ­ XE (X760)
1
T4N12868
Rear Rocker Panel Tape R/H ­ XE (X760)
1
C2Z19587
Rocker panel protection kit ­ XF (X250)
1
TOOLS:
NOTE: Refer to the Equipment Required table in the Service Instruction.
Refer to the Service Instruction/Workshop Manual for any additional required special tools.
WARRANTY:
NOTE: This Service Instruction may not be submitted as a Warranty claim and is customer pay only.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
1/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part number
with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Rocker panel protection kit ­ Install
76.95.97
0.8
­
­
NOTE: Normal Warranty procedures apply.
SERVICE INSTRUCTION:
Equipment Required
The following equipment is required to perform this Service Instruction.
Suitable powder­free (nitrile) gloves
Mist spray bottle
Equal quantities of IPA (isopropyl alcohol) and de­ionized water
Rocker panel protection kit film smoother ­ suggest 3M PA1 applicator wrapped in a soft fine nylon or lycra (as shown in
Step 7)
Micro fiber cloth
WARNING: Suitable powder free (nitrile) gloves must be used when carrying out this Service Instruction.
CAUTION: When unrolling the rocker panel protection kit, do not reverse roll.
CAUTION: When carrying out this Service Instruction, make sure that all traces of polish, grease, etc., are
removed (as shown in Step 2).
CAUTION: This Service Instruction must be carried with ambient and vehicle body temperatures between 16­
25° C.
CAUTION: Film must be applied right first time. Peeling back the film once it has adhered may create
cosmetically unacceptable lines, necessitating a new film.
CAUTION: Cleanliness is critical; dirt under the film may be visible.
CAUTION: Once applied, it is recommended that the film is checked 1­2 hours after application to ensure
correct adhesion, particularly around edges and detailed cut outs.
CAUTION: Vehicle should not be washed for 72 hours following application.
1. Mix the isopropyl alcohol (IPA) and water (50­50) solution in the mist spray bottle.
2.
NOTE: Left­hand rocker panel shown; right­hand
rocker panel similar.
Clean the areas of paintwork using the IPA and water
solution, making sure all grease and dirt is removed.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
2/10
9/6/2016
3.
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
NOTE: Left­hand rocker panel shown; right­hand
rocker panel similar.
Spray the solution onto the area of paintwork as shown.
4.
CAUTION: Avoid touching the adhesive when dry
as this will leave a fingerprint in the film. Tip: spray
some solution onto your fore finger and thumb when
peeling off the backing paper.
NOTE: Left­hand rocker panel shown; right­hand
rocker panel similar.
Peel back the part from the sheet while continuously
spraying the solution onto the adhesive side of the film,
making sure the adhesive is fully saturated.
5.
CAUTION: Do not go over the radius or the film may lift at the edge.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Gently lay the film onto the panel aligning the top corner.
The film should be 2mm in from the radius of the vertical edge and 2mm down from the radius of the top edge.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
3/10
9/6/2016
6.
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
CAUTION: Take care not to trap any air or fluid as
this will be visible particularly on dark vehicles.
NOTE: Left­hand rocker panel shown; right­hand
rocker panel similar.
Once the positioning on the panel is correct, spray additional
solution on to the face of the film; use a suitable rocker
panel protection kit film smoother to follow the pattern of
strokes as shown, using suitable pressure to remove any
fluid and air bubbles to secure the film into place.
Repeated strokes will be required where the film rolls
under the rocker panel.
7.
NOTE: Some fluid residue that cannot be
removed; this is normal.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
4/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
NOTE: Left­hand rocker panel shown; right­hand
rocker panel similar.
Carefully work the solution out of the recess created by the
jacking locator.
8.
NOTE: Left­hand rocker panel shown; right­
hand rocker panel similar.
Wrap the film around the door closure inner edge using
the cloth.
9.
NOTE: Left­hand rocker panel shown; right­
hand rocker panel similar.
Finished position of the film.
10. Repeat Steps 2­9 to the right­hand rocker panel.
11.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Clean the rocker panel in the area shown.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
5/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
12.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Spray the solution onto the area of paintwork as shown.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
6/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
13.
CAUTION: Avoid touching the adhesive when dry as this will leave a fingerprint in the film. Tip:
spray some solution onto your fore finger and thumb when peeling off the backing paper.
Peel back the part from the sheet while continuously spraying the solution onto the adhesive side of the film, making
sure the adhesive is fully saturated.
14.
CAUTION: Do not go over the radius or the film may lift at the edge.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Gently lay the film onto the panel, aligning the top corner.
The film should be 2mm in from the radius of the vertical edge and 2mm down from the radius of the top edge.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
7/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
15.
CAUTION: Take care not to trap any air or fluid as this will be visible particularly on dark vehicles.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Once the positioning on the panel is correct, spray additional solution on to the face of the film; use a suitable rocker
panel protection kit film smoother to follow the pattern of strokes as shown, using suitable pressure to remove any fluid
and air bubbles to secure the film into place.
Repeated strokes will be required where the film rolls under the rocker panel.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
8/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
16.
NOTE: Left­hand rocker panel shown; right­hand rocker panel similar.
Finished position of the film.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
9/10
9/6/2016
JTB00217NAS2 ­ Rocker Panel Stone Chipping | TOPIx
17. Repeat steps 11­16 to the right­hand rocker panel.
http://topix.jaguar.jlrext.com/topix/content/document/view?id=680117
10/10

© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.