LTB00890NAS3

Service Bulletin Details

Public Details for: LTB00890NAS3

Situation: a 'squeak' noise may be evident from the rear of the vehicle while driving.


- 2016 - 2015 -

Page I of 4
TECHNICAL BULLETIN
LTB00890NAS3
27 JUN 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you
are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land Rover service facility to
determine whether this bulletin applies to a specific vehicle.
This reissue replaces all previous versions. Please destroy all previous versions.
I Changes are highlighted in gray I
SECTION: 417-01
Squeak Noise From Tailgate Area While Driving
AFFECTED VEHICLE RANGE:
Discovery Sport (LC)
Model Year:
2015-2016
VIN:
500429-624854
Assembly Plant: Halewood
MARKETS:
NAS
CONDITION SUMMARY:
Situation: A 'squeak' noise may be evident from the rear of the vehicle while driving.
Cause: This may be caused by a clash condition between the tailgate finisher and inner tail lamp(s).
Action: Should a customer express this concern, follow the Service Instruction below.
PARTS:
CZUOOOOlO
Spcr W/Shld GI
1
BNP3996
Circular patch
1
TOOLS:
Refer to Workshop Manual/Service Instruction for any required special tools.
WARRANTY:
6
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to TOPix to obtain the latest repair time.
6
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
. h a auant1tv
. o f zero.
num ber wit
6
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Tail lamp - Modification
86.40.88.29
0.2
07
LR060908
NOTE: Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1. Remove the inner tail lamp assemblies (see TOPIX Workshop Manual, section 417-01: Exterior Lighting).
http://topix.landrover.jlrext.com/topix/service/document/664622
7/7/2016
Page 2 of 4
2. 6
NOTE: Repeat this step on both inner tail
lamps.
Use a suitable cloth to clean the tail lamps in the areas
shown.
3. 6
NOTE: Repeat this step on both inner tail
lamps.
Use a suitable tool to cut the supplied tape circle in half
and remove the backing from the tape circle.
El872 15
4. 6
NOTE: Repeat this step on both inner tail
lamps.
Install the half-tape circle in the area shown.
• The half-tape circle will fold 90° and secure under the
inner tail lamp.
http://topix.landrover.jlrext.com/topix/service/document/664622
7/7/2016
Page 3 of 4
5. The half-tape circle located and installed on the inner tail
lamp.
El 87468
6. Install the new seal as shown.
http://topix.landrover.jlrext.com/topix/service/document/664622
7/7/2016
Page 4 of 4
I'
,
11
I
~
I
I
El93854
7. Install the inner tail lamp assemblies (see TOPIX Workshop Manual, section 417-01: Exterior Lighting).
http://topix.landrover.jlrext.com/topix/service/document/664622
7/7/2016


© dot.report 2024

Use of this information constitutes acceptance for use in an AS IS condition. There are NO warranties, implied or otherwise, with regard to this information or its use. Any use of this information is at the user's risk. It is the responsibility of user to evaluate the accuracy, completeness or usefulness of any information, opinion, advice or other content. EACH USER WILL BE SOLELY RESPONSIBLE FOR ANY consequences of his or her direct or indirect use of this web site. ALL WARRANTIES OF ANY KIND ARE EXPRESSLY DISCLAIMED. This site will NOT BE LIABLE FOR ANY DIRECT, INDIRECT or any other kind of loss.