Service Bulletin

Service Bulletin
March 13, 2015
15-013
01327 Version 1
Driver’s Seat Cushion Cover Comes Loose
AFFECTED VEHICLES
Year
Model
2012–14
TL
Trim
VIN range
Advance
ALL
Advance with SH-AWD
ALL
SYMPTOM
The driver’s seat cushion cover comes loose.
POSSIBLE CAUSES
The seat cushion and TCI (thermal change insert) bag are pushing up against the seat cushion cover and are popping
the tabs.
CORRECTIVE ACTION
Cut out sections of the seat cushion foam to allow the seat cushion cover to fit properly and for the tabs to click into
place.
WARRANTY CLAIM INFORMATION
The normal warranty applies.
Operation Number
Description
Flat Rate Time
Template ID
Failed Part
Number
8510A8
Remove driver’s seat and cut
out foam sections.
0.7 hr
15-013N
81531-TK5-L61ZA
Defect Code:
07403
Symptom Code: 06201
Skill Level:
Repair Technician
CLIENT INFORMATION: The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Acura automobile dealer.
© 2015 American Honda Motor Co., Inc. – All Rights Reserved
Page 1 of 5
REPAIR PROCEDURE
1. Remove the driver’s seat. See the electronic service manual for more information.
2. Peel the seat cushion cover and TCI bag to expose the seat cushion.
3. Loosely install the cushion and recliner covers (removed in step 1) to the seat frame and mark a reference line with
a permanent felt tip pen as shown.
4. Remove the seat cushion and recliner covers, then use a ruler to mark a second cut line 10 mm above the
reference line.
Page 2 of 5
5. Use a ruler to measure and mark the seat cushion following the second rib lines as shown.
6. Carefully cut the foam sections out with a sharp razor blade.
Page 3 of 5
7. Use a felt tip pen to mark the front of the seat cushion as shown.
8. Carefully cut out the foam sections.
Page 4 of 5
9. Carefully cut out the last foam section.
10. Reassemble the driver’s seat, then reinstall all parts and panels in reverse order. See the electronic service manual
for more information.
END.
Page 5 of 5