K430NAS1

Page 1 of 6
TECHNICAL BULLETIN
K430NAS1
02 NOV 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you
are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Jaguar service facility to
determine whether this bulletin applies to a specific vehicle.
SECTION: 501-17
Service Action: Roof Opening Panel Air Deflector Springs Displaced
AFFECTED VEHICLE RANGE:
F-PACE (X761)
Model Year:
VIN:
Assembly Plant:
2017
045409-062601
Vehicles With: Roof Opening Panel
Solihull
MARKETS:
NAS
CONDITION SUMMARY:
Situation: An issue has been identified on a limited number of vehicles within the listed Affected Vehicle Range where
the roof opening glass panel cannot be closed and/or the wind deflector spring may become displaced.
Action: Retailers are required to HOLD affected new vehicles that are within your control and refrain from releasing the
vehicles for new vehicle sale pending completion of the Service Instruction detailed in this Technical Bulletin. Unsold
vehicles should have this performed as part of the Pre-Delivery Inspection (PDI) process but must have it completed
prior to vehicle handover to the customer.
Affected vehicles already in the hands of customers should be updated at the next available opportunity.
PARTS:
NOTE: Order only the expected percentage demand of parts identified.
DESCRIPTION
Seal
PART No./SUNDRY CODE
T2H26120
QTY./VALUE
2
EXPECTED % of VEHICLES REQUIRING PARTS
100
SPECIAL TOOLS:
Refer to Workshop Manual/Service Instruction for any required special tools.
WARRANTY:
NOTE: Check DDW to ensure that a vehicle is affected by this program prior to undertaking any rework
action.
At the time of confirming a booking for vehicle repair, ensure that all outstanding Recalls and Service Actions are identified
to ensure the correct parts are available and adequate workshop time is allocated for repairs to be completed at one visit.
Warranty claims must be submitted quoting Program Code K430 together with the relevant Option Code from the table.
SRO and parts information is included for information only. The Option Code(s) that allows for the drive in / drive out
allowance can only be claimed if the vehicle is brought back into the workshop for this action alone to be undertaken.
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016
Page 2 of 6
This program is valid for a limited time only. Warranty claims with a repair date prior to the 31 October 2018 closure date
must be submitted or payment within 30 calendar days of completion of the repair.
Repair procedures are under constant review and therefore times / prices are subject to change; those quoted here must be
taken as guidance only. Refer to TOPIx to obtain the latest repair time.
PROGRAM
CODE
OPTION
CODE
DESCRIPTION
SRO
TIME
(HOURS)
PARTS/SUNDRY QTY./VALUE
CODE
K430
B
Install the edge finisher on the
roof opening panel
76.82.62 0.10
T2H26120
2
K430
C
Install the edge finisher on the
roof opening panel
Drive in/drive out
76.82.62 0.10
10.10.10 0.20
T2H26120
-
2
-
Normal Warranty policies and procedures apply.
SERVICE INSTRUCTION:
1. Switch the ignition ON (engine not running).
2. Open the roof opening panel to its fully open position.
3. Switch the ignition OFF.
4.
NOTE: Left-side shown; right-side similar.
NOTE: Parts shown removed for clarity.
Locate the area shown.
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016
Page 3 of 6
5. Cut and discard 20 mm from the rubber seal.
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016
Page 4 of 6
6.
NOTE: Right-side shown; left-side similar.
NOTE: Seal length: 60 mm.
Install the rubber seal
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016
Page 5 of 6
7.
NOTE: Right-side shown; left-side similar.
Visually check that the rubber seal is installed correctly as shown.
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016
Page 6 of 6
8. Repeat steps 4-7 to the other side.
9. Switch the ignition ON (engine not running).
10. Close the roof opening panel.
11. Switch the ignition OFF.
http://topix.jaguar.jlrext.com/topix/service/procedure/705947/ODYSSEY_FSA/G204474... 11/11/2016