PIT5165A
Service Bulletin Details
Public Details for: PIT5165A
This preliminary information communication provides information to the technician on the step to replace the power steering cooler. Technician will need to block off the hoses near the cooler connection with appropriate clamps. After the ho
- 2013 - 2012 - 2011 - 2010 - 2009 - 2008 - 2007 -
Models from 2013
| 2013 BUICK ENCLAVE |
| 2013 CHEVROLET TRAVERSE |
| 2013 GMC ACADIA |
Models from 2012
| 2012 BUICK ENCLAVE |
| 2012 CHEVROLET TRAVERSE |
| 2012 GMC ACADIA |
Models from 2011
| 2011 BUICK ENCLAVE |
| 2011 CHEVROLET TRAVERSE |
| 2011 GMC ACADIA |
Models from 2008
| 2008 BUICK ENCLAVE |
| 2008 GMC ACADIA |
| 2008 SATURN OUTLOOK |
Models from 2007
| 2007 GMC ACADIA |
| 2007 SATURN OUTLOOK |
Bulletin No.: PIT5165A Date: Dec-2012 Subject: Replacing Power Steering Cooler Models: 2008 - 2013 Buick Enclave 2009 - 2013 Chevrolet Traverse 2007 - 2013 GMC Acadia 2007 - 2010 Saturn Outlook This PI was superseded to update model years and add warranty information. Please discard PIT5165. The following diagnosis might be helpful if the vehicle exhibits the symptom(s) described in this PI. Condition/Concern Replacing a leaking or damaged power steering cooler without introducing a lot of air into the system. Recommendation/Instructions When replacing a power steering cooler, perform the following steps: 1. Block off the hoses near the cooler connection with appropriate clamps. 2. Disconnect the cooler from the lines and remove the cooler. 3. Prefill the new cooler on the bench and cap off the pre-filled cooler ends for installation. 4. Install the new pre-filled cooler on the vehicle and remove the clamps on the hoses. 5. Follow the Power Steering System Bleed Procedure in service information. Warranty Information For vehicles repaired under warranty use: Labor Operation Description Labor Time E8940 Power Steering Fluid Cooler Replacement Use Published Labor Operation Time Please follow this diagnostic or repair process thoroughly and complete each step. If the condition exhibited is resolved without completing every step, the remaining steps do not need to be performed. GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information. WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION 1