LTB01019NAS1

Page 1 of 7
LTB01019NAS1
TECHNICAL
BULLETIN
27 APR 2017
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by
trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these
Technicians of conditions that may occur on some vehicles, or provides
information that could assist in proper vehicle service. The procedures
should not be performed by 'do-it-yourselfers'. If you are not a Retailer,
do not assume that a condition described affects your vehicle. Contact
an authorized Land Rover service facility to determine whether this
bulletin applies to a specific vehicle.
INFORMATION
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017
Page 2 of 7
SECTION:
419-00: Electronic Feature Group
SUBJECT/CONCERN:
Tow Assist or Park Assist - Towbar Alignment
AFFECTED VEHICLE RANGE:
MODEL:
Discovery Sport (LC)
MODEL YEAR:
2015-2016
VIN:
501001-544577
ASSEMBLY PLANT:
Halewood
MARKETS:
NORTH AMERICA
CONDITION SUMMARY:
SITUATION:
The graphical towbar display may not be aligned to the physical towbar
position.
CAUSE:
This may be caused by the towbar graphical position not having been
validated for all model variants.
ACTION:
Should a Customer express this concern, follow the Service Instruction
below.
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017
Page 3 of 7
PARTS:
PART NUMBER
DESCRIPTION
QUANTITY:
LR092733
Rear Camera
1
LR092728
Rear Camera
1
LR096450
Bezel
1
TOOLS:


Jaguar Land Roverapproved
Midtronics battery
power supply
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017
Page 4 of 7


Jaguar Land Roverapproved
diagnostic tool with
latest SDD software
and Calibration File
WARRANTY:
NOTES:
◾ Repair procedures are under constant review, and therefore
times are subject to change; those quoted here must be taken
as guidance only. Always refer to TOPIx to obtain the latest
repair time.
◾ DDW requires the use of causal part numbers. Labor only claims
must show the causal part number with a quantity of zero.
DESCRIPTION
SRO
TIME
(HOURS)
CONDITION
CODE
https://topix.landrover.jlrext.com/topix/service/document/789122
CAUSAL
PART
5/4/2017
Page 5 of 7
DESCRIPTION
SRO
TIME
(HOURS)
CONDITION
CODE
CAUSAL
PART
Camera - Rear View Renew
86.54.40
0.4
42
LR092733
Configure Parking and
Camera Module
86.90.93
0.8
42
LR092733
NOTE:
Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1
If the Customer concern is still present following towbar fitment
and using the Jaguar Land Rover-approved diagnostic tool to
select the correct towbar type, go to Step 2.
2
Install a new rear camera and bezel (see TOPIx Workshop
Manual section 413-13: Parking Aid - Parking Aid Camera).
3
CAUTIONS:
◾ A Jaguar Land Rover-approved Midtronics battery
power supply must be connected to the vehicle
battery during diagnosis / module programming.
◾ Make sure all ignition ON/OFF requests are carried
out; failure to perform these steps may cause
damage to control modules in the vehicle.
NOTE:
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017
Page 6 of 7
The Jaguar Land Rover-approved diagnostic tool must
be loaded with SDD148.03 v.259 (or later).
Connect the Jaguar Land Rover-approved Midtronics battery
power supply to the vehicle battery.
4
Switch the ignition ON (engine not running).
5
Connect the Jaguar Land Rover-approved diagnostic tool to the
vehicle and begin a new session.
6
Follow the on-screen prompts, allowing the diagnostic tool to
read the VIN, identify the vehicle, and initiating the data collect
sequence.
7
Select Diagnosis from the Session Type screen.
8
Select the Selected Symptoms tab and then select:
Electrical - Driving aids - Camera display - Tow
assist
9
Select continue.
10
Select the Recommendations tab.
11
Select Run to perform the 'Special applications - Camera
Replacement - Tow Bar Configuration' option.
12
Follow all on-screen instructions to complete this task, ensuring
all Diagnostic Trouble Codes (DTC) are cleared.
13
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017
Page 7 of 7
When all tasks are complete, select the Session tab and then
select the Close Session option.
14
Disconnect the diagnostic tool and battery power supply from
the vehicle.
https://topix.landrover.jlrext.com/topix/service/document/789122
5/4/2017