TSB-BOD103

GROUP
BODY
MODEL
2012-2013MY
Optima (QF)
NUMBER
DATE
103
September 2013
TECHNICAL SERVICE BULLETIN
SUBJECT:
PANORAMA SUNROOF & SUNSHADE MOTOR
REPLACEMENT
This bulletin provides the procedure to replace the panorama sunroof and sunshade motors on
some 2012-2013MY Optima (QF) vehicles, produced from August 9, 2011 to August 14, 2013,
which may exhibit a loss of the “one-touch” open/close feature of the sunshade and/or panorama
roof. This condition may be attributed to the exposure of the ECU in each motor to static
electricity, causing a loss of initialization memory. To correct this concern, install the new sunroof
and sunshade motors by following the procedure outlined in this bulletin.
Refer to the table below to differentiate between the sunroof and sunshade motors.
Sunroof Motor
P/N 81671 2T210
Sunshade Motor
P/N 81671 2T211
 NOTICE
VINs which start with KNA are designated Optima (TF/TF HEV) and built in South
Korea. VINs that start with 5XX are designated Optima (QF) and built in the United
States. This TSB applies to Optima (QF) only.
File Under: 
Circulate To:
X General Manager


X Service Advisors

X Technicians

X Service Manager

X Parts Manager

X Body Shop Manager 
X Fleet Repair
Page 2 of 8
SUBJECT:
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
 NOTICE
After replacing the panorama sunroof & sunshade motors, perform the panorama
sunroof motor initialization.
Service Procedure:
1.
Remove the weather-stripping
from the front and rear doors.
(A)
CAUTION
Wear disposable gloves to avoid
damaging the headliner.
2.
A
Remove two screws securing the grab
handles (B). Make sure to remove all
four (4) grab handles.
B
3.
Use a plastic prying tool to remove the
lenses from the rear dome light (C).
Remove two screws securing the rear
dome light body and disconnect the
electrical connector.
TSB: BOD 103 Optima (QF) September 2013
C
Page 3 of 8
SUBJECT:
)4.
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
Open the sunglass holder and remove
two screws securing the front dome
light (D). Gently pull down on the front
of the dome light to release the
mounting clips, disconnect the electrical
connector and carefully remove the
dome light from the headliner.
D
Partially detach the A-pillar trim panel
(E) using both hands. Then, use a pair
of needle nose pliers to rotate and
detach the mounting clip (F), as shown.
5.
G
E
F
CAUTION
Avoid damaging the side curtain
airbag (G) while removing the Apillar trim panel.
6.
Use a panel remover (H) to gently
detach the lower attachment point (I)
for the A-pillar trim panel.
I
 NOTICE
Make sure to replace any broken
clips before reinstalling the A-pillar
trim panel.
H
P/N: 82315 33020
Description: Fastener-DR Trim
TSB: BOD 103 Optima (QF) September 2013
Page 4 of 8
SUBJECT:
7.
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
Use a trim panel remover (J) with a
long shaft to pry-off the upper
attachment point (K) for the C-pillar trim
panel (L), as shown.
K
L
8.
J
Continue using the panel remover (J) to
gently detach all other mounting
locations for the C-pillar trim panel (L).
L
 NOTICE
J
Make sure to replace any broken
clips before reinstalling the Cpillar trim panel.
P/N: 82315 33020
Description: Fastener-DR Trim
 NOTICE
Examine all mounting clip
locations for the C-pillar panel.
K
TSB: BOD 103 Optima (QF) September 2013
Page 5 of 8
SUBJECT:
)9.
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
Move the front seat as far forward as
possible and use a plastic prying tool to
remove the front door threshold panel
(M).
M
 NOTICE
Make sure to re-install any clips
that may fall off the panel following
removal.
10.
Use a plastic prying tool to remove the
rear door threshold panel (N).
 NOTICE
Make sure to re-install any clips
that may fall off the panel following
removal.
N
11.
Lower the safety belt to its lowest
setting and use a trim panel remover to
detach all mounting locations for the
upper (O) and lower (P) B-pillar trim
panels.
O
 NOTICE
Make sure to replace any broken
clips before reinstalling the Bpillar trim panels.
P
P/N: 82315 33020
Description: Fastener-DR Trim
TSB: BOD 103 Optima (QF) September 2013
Page 6 of 8
SUBJECT:
12.
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
Gently apply downward pressure to the
headliner (Q) to create an access gap
to the sunshade and the sunroof glass
motors.
 NOTICE
Q
Make sure to replace any broken
clips
before
reinstalling
the
headliner.
P/N: 85849 1M000AS
Description: Clip-Trim MTG
13.
Disconnect the power connectors from
the sunshade (R) and sunroof (S)
motors.
S
14.
Remove three T20 Torx® head screws
securing the sunshade motor (R) and
three T20 Torx® head screws securing
the sunroof motor (S).
TSB: BOD 103 Optima (QF) September 2013
S
R
R
Page 7 of 8
SUBJECT:
15.
)
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
Install the new sunshade motor (R) and
sunroof motors (S) using the original
T20 Torx® head screws and reconnect
the electrical connectors.
T20 Torx® Screw Tightening Torque:
2.8 lb-ft (3.8 Nm)
S
16.
Install all other removed components by reversing the order of removal.
17.
Perform the panorama sunroof initialization procedure as follows:
R
1. Turn the ignition switch to the ON position and close the sunroof completely.
2. Release the control lever.
3. Push and hold the control lever forward (for more than 10 seconds) until the sunroof
tilts and slightly moves. Then, release the lever.
4. Push the sunroof control lever forward in the direction of close until the sunroof
operates as follows:
SUNSHADE OPEN → TILT OPEN →SLIDE OPEN → SLIDE CLOSE →SUNSHADE
CLOSE → Then, release the control lever.
When this is complete, the sunroof system is reset.
TSB: BOD 103 Optima (QF) September 2013
Page 8 of 8
SUBJECT:
PANORAMA SUNROOF & SUNSHADE MOTOR REPLACEMENT
REQUIRED PART:
Part Name
Part No.
Qty.
Sunroof Motor
81671 2T210
1
Sunshade Motor
81671 2T211
1
Figure
AFFECTED VEHICLE PRODUCTION RANGE:
Model
Production Date Range
Optima (QF)
August 9, 2011 to August 14, 2013
WARRANTY INFORMATION:
Claim Causal
N
C
Qty.
Type
P/N
Code Code
W
81671
2T210
1
N66
C13
Repair
Description
Labor Op
Code
Op
Time
Replacement
P/N
Qty.
(BOD 103)
Panorama
Sunroof &
Sunshade Motor
Replacement
81631F00
0.8
M/H
81671 2T211
1
Include P/N 82315 33020 and P/N 85849 1M000AS, as needed, in this claim.
 NOTICE
VINs which start with KNA are designated Optima (TF/TF HEV) and built in South
Korea. VINs that start with 5XX are designated Optima (QF) and built in the United
States. This TSB applies to Optima (QF) only.
TSB: BOD 103 Optima (QF) September 2013