LTB01022NAS1

Page 1 of 5
TECHNICAL BULLETIN
LTB01022NAS1
04 NOV 2016
© Jaguar Land Rover North America, LLC
NOTE: The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and
equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or
provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you
are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land Rover service facility to
determine whether this bulletin applies to a specific vehicle.
SECTION: 501-00
'Rattle' Noise From Glovebox Area / Loose BCM Cover
AFFECTED VEHICLE RANGE:
Discovery Sport (LC)
Model Year:
2015 Onwards
VIN:
501001 Onwards
Assembly
Halewood
Plant:
MARKETS:
NAS
CONDITION SUMMARY:
Situation: A 'rattle' noise may be evident from the glovebox area. Upon further inspection, checking the glovebox
results in no fault found.
Cause: This may be caused by the Body Control Module (BCM) cover in the front passenger footwell which can become
loose and generate unwanted noise.
Action: Should a Customer express this concern, follow the Service Instruction below.
WARRANTY:
NOTE: Repair procedures are under constant review, and therefore times are subject to change; those
quoted here must be taken as guidance only. Always refer to TOPIx to obtain the latest repair time.
NOTE: DDW requires the use of causal part numbers. Labor only claims must show the causal part
number with a quantity of zero.
DESCRIPTION
SRO
TIME (HOURS)
CONDITION CODE
CAUSAL PART
Panel - Closing - Renew
76.46.27
0.1
07
LR059777
NOTE: Normal Warranty procedures apply.
SERVICE INSTRUCTION:
1. Open the front right door.
2. Remove the Body Control Module (BCM) cover from the passenger footwell.
http://topix.landrover.jlrext.com/topix/service/document/707493?highlight=LTB01022N...
11/14/2016
Page 2 of 5
3. Visually inspect the position of the wiring harness as it may be positioned over the floor carpet as illustrated.
• If the wiring harness is not positioned over the floor carpet, go to Step 5.
• If the wiring harness is positioned over the floor carpet, go to Step 4.
http://topix.landrover.jlrext.com/topix/service/document/707493?highlight=LTB01022N...
11/14/2016
Page 3 of 5
4. Position the wiring harness behind the floor carpet as illustrated.
http://topix.landrover.jlrext.com/topix/service/document/707493?highlight=LTB01022N...
11/14/2016
Page 4 of 5
5. Install the BCM cover in the passenger footwell.
6. Visually check that there is no gap between the BCM cover and the floor carpet and that it is securely installed.
http://topix.landrover.jlrext.com/topix/service/document/707493?highlight=LTB01022N...
11/14/2016
Page 5 of 5
7. Close the front right door.
http://topix.landrover.jlrext.com/topix/service/document/707493?highlight=LTB01022N...
11/14/2016