A001463 2033576-

Technical Service Bulletin
00 Audi engine oil-filling procedure
00 14 63 2033576/2 May 28, 2014. Supersedes Technical Service Bulletin Group 00 number 13-49 dated May 14,
2013 for reasons listed below.
Model(s)
Year
VIN Range
Vehicle-Specific Equipment
All
2008 - 2016
All
Not Applicable
Condition
REVISION HISTORY
Revision
Date
Purpose
2
-
Revised header data (Added model years)
1
5/14/2013
Initial publication
Although the correct amount of oil was added to the engine during an oil change service, a check of the oil level
shows that the oil level is not okay.
Technical Background
When an unapproved aftermarket speed-filling device is used to add oil to the engine, the increased oil flow rate
may force oil into the intake manifold or combustion chamber, creating the potential for engine damage.
Production Solution
Not applicable.
Service
1. Verify whether or not oil has entered either the intake manifold or the combustion chamber.
2. If oil is found in either of these areas, remove the oil.
3. Fill the engine with the correct amount of oil as listed the in the vehicle’s Fluid Capacity
Table in ElsaWeb. When filling the engine with oil, use overhead oil dispensers, quart
containers of oil, or oil-filling containers that do not completely seal the filler cap receptacle
on the oil separator or valve cover.
4. Allow the oil to drain into the oil pan.
5. Check that the oil level is correct before starting the engine.
© 2014 Audi of America, Inc.
Page 1 of 2
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.
Technical Service Bulletin
Warning:
Do not use aftermarket speed-filling devices and funnels that have an airtight seal at the filler
cap, as they are not approved. Damages caused by speed-filling devices and funnels that have
an airtight seal at the filler cap are not warrantable and will not be reimbursed.
Warranty
This TSB is informational only and not applicable to any Audi warranty.
Additional Information
All parts and service references provided in this TSB (2033576) are subject to change and/or removal. Always
check with your Parts Department and service manuals for the latest information.
© 2014 Audi of America, Inc.
Page 2 of 2
All rights reserved. Information contained in this document is based on the latest information available at the time of printing and is subject to the copyright and other intellectual property rights of
Audi of America, Inc., its affiliated companies and its licensors. All rights are reserved to make changes at any time without notice. No part of this document may be reproduced, stored in a retrieval
system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, nor may these materials be modified or reposted to other sites, without the prior
expressed written permission of the publisher.