L-SB-0031-15

L-SB-0031-15
Rev1
July 28, 2015
Long-Term Vehicle Storage Guidelines
Service
Category
General
Section
Pre-Delivery Service
Market USA
Applicability
YEAR(S)
MODEL(S)
2016
CT200H, ES300H, ES350,
GS F, GS200T, GS350,
GS450H, GX460, IS200T,
IS300, IS350, LS460,
LS600H, LX570, NX200T,
NX300H, RC F, RC200T,
RC300, RC350, RX350,
RX450H
ADDITIONAL INFORMATION
REVISION NOTICE
February 25, 2016 Rev1:
Applicability has been updated to include 2016 model year GS F, GS 200t, GX 460, IS 200t/300,
and RC 200t/300 vehicles.
Any previous printed versions of this bulletin should be discarded.
Introduction
Long-term or off-site storage requires special care to keep vehicles factory fresh and ready for
delivery. The following guidelines should be performed to minimize vehicle component/part
degradation due to extended vehicle storage conditions. Long-term storage can affect a vehicle's
systems and components. Any problems that are found should be corrected immediately.
Required Tools & Equipment
SPECIAL SERVICETOOLS (SST)
PART NUMBER
QTY
Digital Battery System Analyzer*
00002-V8150-KIT
1
GR8 Battery Diagnostic Station*
00002-MCGR8
1
NOTE
Additional SSTs may be ordered by calling 1-800-933-8335.
* Essential SST.
© 2016 Lexus, a division of Toyota Motor Sales, USA
Page 1 of 5
L-SB-0031-15
Rev1
July 28, 2015
Page 2 of 5
Long-Term Vehicle Storage Guidelines
Warranty Information
OP CODE
DESCRIPTION
TIME
OFP
T1
T2
N/A
Not Applicable to Warranty
–
–
–
–
Procedure
Parking and Paint Protection
•
Storage areas should be paved, well lit, and secure. If your off-site storage lot is not paved,
spread gravel down to minimize mud and dust. Be sure vehicles are driven carefully when
moving them to or from a long-term lot. This will help minimize damage to the paint finish
rom road grit or gravel.
•
Park vehicles from right to left at least three feet apart. Leave enough space front and rear
to easily walk between rows.
•
HVAC vent controls should be set to “Recirc” to minimize dust and odor intrusion.
•
Make sure the plastic door edge protectors are in place and fold in the side view mirror
(if applicable).
•
Anti-rust covers or anti-rust film should remain on vehicle during storage.
1. Anti-rust covers (behind wheel) should be removed during Pre-Delivery Service
(PDS).
2. Anti-rust film (applied to wheel) should be removed just prior to customer delivery.
•
Wash vehicles frequently.
Battery
•
Turn off all electrical accessories, make sure windows and sunroof are closed and check
that the transmission is in “Park” (first or reverse for manual transmission vehicles). Do
NOT apply the parking brake.
•
Test batteries monthly (more often in high heat or cold areas), using the Digital Battery
System Analyzer (P/N 00002-V8150-KIT). Refer to Service Bulletin PG001-06, “Battery
Maintenance for In-Stock Vehicles & Pre-Delivery,” for complete battery maintenance
procedures.
•
To reduce battery drain during long-term storage, remove the battery ground (–) cable of
each vehicle and reinstall just before delivery to the customer. Locate the current PDS
Service Bulletin on TIS for complete details.
•
If a hybrid vehicle is put into storage, the state of charge (SOC) of its HV battery and
auxiliary battery will gradually decrease. To prevent the auxiliary battery from becoming
discharged during storage, proper maintenance is required. Refer to the applicable
“Maintenance for HV & Auxiliary Batteries” Service Bulletin for procedure and additional
information.
© 2016 Lexus, a division of Toyota Motor Sales, USA
L-SB-0031-15
Rev1
July 28, 2015
Page 3 of 5
Long-Term Vehicle Storage Guidelines
1
Procedure (Continued)
Tire Inflation Pressure
If the vehicle is parked for long periods without being moved, a flat spot may develop on each
tire surface in contact with the ground, even if the tires are inflated to specification. Tire inflation
pressure should be checked once a month.
Tire inflation pressure for storage only: 45 psi.
Parts Rust
If the vehicles in your storage area are exposed to a sea breeze and/or significant precipitation,
corrosion with rust in some parts may occur.
If rust is found, remove it, and treat it by applying rust inhibitor to prevent recurrence.
Engine Starting and Vehicle Movement
If the vehicle is stored over an extended period of time, starting and running the engine periodically
will ensure smooth running operation.
1. If the vehicle is stored over an extended period of time, starting and running the engine
periodically will ensure smooth running operation.
NOTE
Be sure to allow sufficient clearance at the rear of the vehicle to prevent other vehicles
stored behind from getting damaged by exhaust gas.
2. Move the vehicle at least 30 feet to lubricate the transmission and differential and prevent
tire flat-spot damage.
3. Raise engine speed above 3,000 rpm (N/A for hybrid vehicles) 10 times to eliminate
moisture from the exhaust.
A/C Compressor Lubrication
To minimize the possibility of damage to the A/C compressor while storing a vehicle, perform
the following recommended maintenance procedures at least once a month to lubricate
the compressor.
1. Turn off A/C and blower switches prior to starting engine.
2. Start and warm up the engine until engine idle drops below 1,000 rpm.
© 2016 Lexus, a division of Toyota Motor Sales, USA
L-SB-0031-15
Rev1
July 28, 2015
Page 4 of 5
Long-Term Vehicle Storage Guidelines
Procedure (Continued)
3. Turn on the A/C system (including the rear A/C) using the following settings:

A/C Switch: ON

Blower Speed: High

Engine Speed: Below 1,000 rpm
4. Keep A/C ON with engine idling for at least one minute (in dual A/C vehicles, leave on for
two minutes).
5. Turn OFF A/C system and stop engine.
Disc Brake Rotor Surface Rust Removal
The brake rotors are made of cast iron, so they may show gradual buildup of surface rust during
long-term storage. At least once every 2 months, drive the vehicle and use the brakes normally,
stopping from about 30 mph at least 20 times. This regular usage will help prevent severe rust
buildup and the possibility of unwanted brake vibration concerns due to rust.
Figure 1. Slight Rust on Rotor (Easy to Remove
by Braking)
Figure 1. Slight Rust on Rotor (Easy to Remove
by Braking)
NOTE
If the brake vibration still occurs after the braking cycle, determine the root cause of the
brake vibration and repair.
Brake rotor resurfacing may be required if the rust was severe and resulted in excessive
rotor thickness variation.
© 2016 Lexus, a division of Toyota Motor Sales, USA
L-SB-0031-15
Rev1
July 28, 2015
Page 5 of 5
Long-Term Vehicle Storage Guidelines
Procedure (Continued)
Summary Chart for Long-Term Storage
Below are items that should be checked periodically and their frequency.
Action
Frequency
Tire Inflation Pressure Check
Monthly
Parts Rust Inspection
Monthly
A/C Compressor Lubrication
Monthly
Test/Charge Disconnected Battery to 12.6 V
Monthly
Disc Brake Rotor Surface Rust Removal
Every 8 weeks
Engine Starting and Vehicle Movement
Every 6 weeks
Rapgard™ Removal
After 90 days
Tyvek® Removal
After 12 months
A combination of proper vehicle receipt, Pre-Delivery Service, and vehicle storage is the only way
to maintain factory fresh vehicles. Lexus’ goal is to deliver 100% problem-free cars and trucks.
With your commitment to quality and customer satisfaction, we can reach that goal. Review this
bulletin often and be sure new employees are aware of the policies and procedures outlined
herein, as individual training in proper inspection, Pre-Delivery Service, and storage and handling
techniques are essential to ensure high delivery quality.
Here is a list of additional resources, which will help you with vehicle receipt, inspection, and
storage procedures.
Reference and Training Materials
•
CRIB Bulletin #165, “Acid Rain Finish Damage – Prevention and Repair”
•
UoT e-Learning Course E257 Vehicle Delivery Quality – Paint Finish Repair
•
Service Bulletin BO015-91, “Prevention and Repair of Acid Rain Damage”
•
Service Bulletin BO029-91, “New Vehicle Washing Schedule for Paint Protection”
•
Service Bulletin PG001-06, “Battery Maintenance for In-Stock Vehicles & Pre-Delivery”
•
Service Bulletin PA001-05, “Iron Particle Rust Contamination Repair”
•
Service Bulletin PG004-94, “Dealer Removal Procedures for Rapgard™ Protective Film”
•
Service Bulletin PG006-07, “Removal of Tyvek® Protective Film”
•
Service Bulletin PD001-04, “Wheel Film for Brake Rotor Rust Prevention”
© 2016 Lexus, a division of Toyota Motor Sales, USA