A18-025

Service Bulletin
18-025
March 16, 2018
Version 1
2016 Pilot: MIL Comes On with DTC P0300 - P0306 or P219A/B
AFFECTED VEHICLES
Year
Model
Trim
VIN Range
2016
Pilot
2WD ALL
5FNYF5…GB000001 - 5FNYF5…GB033297
4WD ALL
5FNYF6…GB000001 - 5FNYF6…GB068026
NOTE
The vehicle must have at least 5000 miles or more on the odometer and must have a build date of 3/1/2016 or earlier.
SYMPTOM
The MIL comes on with DTC P0300 (random misfire detected) and/or P0301-P0306 (cylinder misfire detected) or
P219A/B (air-fuel ratio variation of cylinder (bank 1, rear bank/bank 2, front bank).
PROBABLE CAUSE
The injectors were installed improperly at the factory and/or contamination was introduced to the fuel system that is
affecting the fuel flow.
CORRECTIVE ACTION
Replace the fuel injectors.
CUSTOMER INFORMATION:The information in this bulletin is intended for use only by skilled technicians who have the proper tools, equipment, and
training to correctly and safely maintain your vehicle. These procedures should not be attempted by “do-it-yourselfers,” and you should not assume
this bulletin applies to your vehicle, or that your vehicle has the condition described. To determine whether this information applies, contact an
authorized Honda automobile dealer.
©
2018 American Honda Motor Co., Inc. — All Rights Reserved
Page 1 of 2
PARTS INFORMATION
Part Name
Part Number
Quantity
Fuel Injector Set
16010-RLV-315
1
Fuel Joint Pipe Set
16012-R9P-315
1
Front Gasket
17055-R9P-A01
1
Rear Gasket
17065-R9P-A01
1
Intake Manifold Gasket
17101-RLV-A01
1
Throttle Body Gasket
17102-RLV-A01
1
EGR Seal
17103-RLV-A01
2
EGR Pipe Gasket A
18716-RB0-G01
1
WARRANTY CLAIM INFORMATION
The normal warranty applies.
NOTE
The vehicle must have at least 5000 miles or more on the odometer and must have a build date of 3/1/2016 or earlier.
Operation
Number
Description
Flat Rate
Time
Defect
Code
Symptom
Code
Template
ID
Failed Part Number
121110
Replace the fuel
injectors.
2.5 hrs.
08001
03217
A18025A
16010-RLV-305
Skill Level: Repair Technician
REPAIR PROCEDURE
1. Relieve the fuel pressure. Refer to the service information.
2. Remove the intake manifold and intake manifold base. Refer to the service information.
3. Remove the high pressure fuel pump cover. Refer to the service information.
4. Remove the fuel rail cover. Refer to the service information.
5. Remove the fuel joint pipe. Refer to the service information.
6. Remove the fuel rail and injector. Refer to the service information.
7. Remove the injectors from the fuel rail. Refer to the service information.
8. Install the parts in the reverse order of removal. Refer to the service information.
9. Check for fuel leaks. Refer to the service information.
10. Do an all DTC check, and clear DTCs from all systems.
END
Page 2 of 2