PI1532A

Bulletin No.: PI1532A
Date: Nov-2015
Subject:
MIL Illuminated, DTC P16F3 with Engine Power is Reduced Message Displayed in DIC
Models:
2014 Chevrolet Corvette
Attention:
This PI also applies to any of the above models that may be Export vehicles.
This PI has been revised to update the Condition/Concern. Please discard PI1532.
Condition/Concern
Some customers may comment on the malfunction indicator lamp (MIL) illuminated with an ‘Engine Power is Reduced’ message displayed in the DIC.
Technicians may find diagnostic trouble code (DTC) P16F3 set in history. This code may have set in the Engine Control Module during a cold engine start.
Recommendation/Instructions
If following the diagnostic instructions for this code above in Service Information (SI) does not lead to a root cause, update the Engine Control Module (ECM)
software.
An updated software calibration has been released to address this concern.
Update the K20 Engine Control Module (ECM) using the Service Programming System (SPS) with the latest calibrations available on TIS2WEB. Refer to the
K20 Engine Control Module: Programming and Setup in SI.
Important: Verify the battery voltage is more than 12 volts but less than 16 volts before proceeding with reprogramming. The battery must be fully charged
BEFORE reprogramming.
Important: During reprogramming, the battery voltage must be maintained within the proper range of 12-15.5 volts. CONNECT the approved Midtronics®
PSC 550 Battery Maintainer (SPS Programming Support Tool (EL-49642) to the vehicle or the GR8 (EL50313) in the power supply mode.
Warranty Information
For vehicles repaired under the Powertrain coverage, use the following labor operation. Reference the Applicable Warranties section of Investigate Vehicle
History (IVH) for coverage information.
Labor Operation
Description
Labor Time
2810075
Engine Control Module Reprogramming with SPS
Use Published Labor
Operation Time
GM bulletins are intended for use by professional technicians, NOT a "do-it-yourselfer". They are written to inform these technicians of conditions that may
occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools,
safety instructions, and know-how to do a job properly and safely. If a condition is described, DO NOT assume that the bulletin applies to your vehicle, or that
your vehicle will have that condition. See your GM dealer for information on whether your vehicle may benefit from the information.
WE SUPPORT VOLUNTARY TECHNICIAN CERTIFICATION
1