08-052-14
Service Bulletin Details
Public Details for: 08-052-14
Fog lamps stay on with high beams this bulletin involves performing a misc function procedure, for proper fog lamp operation. The customer may notice that the fog lamps stay on when the headlamp high beams are on.
- 2014 -
Models from 2014
2014 FIAT 500L |
NUMBER: GROUP: DATE: 08-052-14 Electrical June 10, 2014 This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of Chrysler Group LLC. THIS SERVICE BULLETIN IS ALSO BEING RELEASED AS RAPID RESPONSE TRANSMITTAL (RRT) 14-045. ALL APPLICABLE SOLD AND UN-SOLD RRT VIN's HAVE BEEN LOADED. TO VERIFY THAT THIS RRT SERVICE ACTION IS APPLICABLE TO THE VEHICLE, USE VIP OR PERFORM A VIN SEARCH IN TECHCONNECT. ALL REPAIRS ARE REIMBURSABLE WITHIN THE PROVISIONS OF WARRANTY. THE wiTECH SOFTWARE LEVEL MUST BE AT 14.03 OR HIGHER TO PERFORM THIS PROCEDURE. SUBJECT: Fog Lamps Stay On With High Beams OVERVIEW: This bulletin involves performing a Misc Function procedure, for proper fog lamp operation. MODELS: 2014 (BF) 500L NOTE: This bulletin applies to vehicles built on or before October 25, 2013 (MDH 1025XX) equipped with Fog Lamps (sales code LNJ). SYMPTOM/CONDITION: The customer may notice that the fog lamps stay on when the headlamp high beams are on. DIAGNOSIS: Using a Scan Tool (wiTECH™) with the appropriate Diagnostic Procedures available in TechCONNECT, verify no DTC's are set. If DTC's are present record them on the repair order and repair as necessary before proceeding further with this bulletin. If a customer’s VIN is listed in VIP or your RRT VIN list, perform the repair. For all other customers that describe the symptom/condition, perform the Repair Procedure. REPAIR PROCEDURE: 1. If the vehicle is an unsold unit and still in logistic mode (ship mode) it must put in customer mode to complete this procedure. 2. Using wiTECH select the BCM icon, and then go to Misc Function and select “Exit Logistic Mode”. 08-052-14 -2- NOTE: Once the vehicle is taken out of Logistic Mode, it can NOT be put back into Logistic Mode. 3. Now perform Misc Function “Enable Front Fog Lamp Output”. Enable front fog lamp dropout will now appear, select “Continue” to complete this procedure. 4. Using wiTECH clear any DTCs which may have been set during this procedure. POLICY: Reimbursable within the provisions of the warranty. TIME ALLOWANCE: Labor Operation No: 18-19-02-J9 Description Module, Body Control (BCM) - 6 - Electrical and Body Enable Front Fog Lamp Output (1 - Semi-Skilled) FAILURE CODE: ZZ Skill Category Service Action Amount 0.2 Hrs.